Static compaction, Standard Proctor, Unconfined compressive strength, Permeability, Compaction energy.
Abstract:
Ground improvement using mechanical stabilization is commonly applied by performing the standard Proctor compaction test, which requires a significant quantity of soil, usually obtained from open pits. A static compaction test is an alternative laboratory compaction test. Although researchers have shown that the results of miniature size static compaction tests are comparable with that of standard Proctor tests in terms of the maximum dry density and the optimum water content, no attempt has been made to compare the two fundamental properties of the compacted soil: undrained shear strength and hydraulic conductivity. The scope of this investigation was to estimate the level of static compaction energy required to (1) obtain a compaction curve similar to that of the standard Proctor test; (2) reconstruct compacted soils using the standard Proctor and static compaction tests at the optimum water content; and (3) compare the undrained shear strength and hydraulic conductivity of compacted soils. The compacted soils at the predetermined energy level were subjected to hydraulic conductivity tests using the rigid-wall falling-head permeability method. Undrained shear strength tests were performed by employing a high-capacity laboratory vane shear apparatus on compacted samples of both the standard Proctor and static compaction tests. The present investigation revealed that the static compaction test, requiring about only 10% of the soil necessary to perform the standard Proctor method, provides comparable results in regard to hydraulic conductivity and undrained shear strength.
Kamil KAYABALI, Turgay BEYAZ, İlknur KARAASLAN ÖZDEMİR, Deniz YILMAZ
Indexed In · Volume 173 / April 2024
A simple and practical tool for indirect determination of the unconfined compressive strength of most common construction materials
Authors:
Kamil KAYABALI, Turgay BEYAZ, İlknur KARAASLAN ÖZDEMİR, Deniz YILMAZ
ABSTRACT
Determination of the unconfined compressive strength (UCS) of construction materials in the laboratory is tedious and time-consuming. There have been many attempts to indirectly predict UCS using simpler tools and techniques. One of them is the nail gun. The scope of this investigation is to design a nailer which can be applied all construction materials whose UCS range from 1-100 MPa. In the research, rocks, bricks, and concretes prepared in different cement/sand ratios with different strength ranges were used as materials. The unconfined compressive strength of the materials used in the experiments was first determined by conventional compression tests. The nail penetration depths were determined by conducting experiments on the same materials using a nailer with two different energy levels. An empirical relationship was developed by using nail penetration depths, driving energies, and nail diameters as the independent variables and the UCS determined by the conventional method as the dependent variable. According to the empirical relationship determined by multiple regression analysis, the UCS of building materials can be estimated with significance level of 99% by the nail penetration method. The research also revealed that the UCS of rocks might have a coefficient of variation as high as 30%.
Keywords:
Compressive strength, building materials, nail gun, driving energy.
Investigation of the coefficient of consolidation of fine-grained soils using combined apparatus
Authors:
Ramin ASADİ, Kamil KAYABALI, Mehmet Can BALCI
ABSTRACT
The scope of this investigation is to compare the coefficient of consolidation (cv) values defined by the Taylor’s Square Root of Time Fitting Method, which is obtained from the conventional oedometer tests, with the cv values calculated by Terzaghi’s One Dimensional (1D) Consolidation Theory, which is obtained from the permeability-consolidation tests performed with a combined apparatus specifically designed for this study. In addition, an empirical relation is developed to determine cv using the coefficient of permeability (k) and index properties of the soils. The cv values obtained from the permeability-consolidation tests using the combined apparatus were found to be larger than the cv values defined by the Taylor’s method, which is one of the oedometer tests. The findings showed that the difference was more prominent in the soil samples with a high plasticity. It was also found that the cv calculated by the Taylor’s method exhibited a distribution in a wide range with the increased load depending on the degree of plasticity of the soil. The cv obtained from the combined apparatus it decreased with low load values and increased with higher load levels. The cv obtained by the proposed empirical relationship showed good agreement with the cv defined by permeabilityconsolidation relationships.
https://doi.org/10.19111/bulletinofmre.835936
Keywords:
Coefficient of Consolidation, Coefficient of Permeability, Oedometer Test, Combined Apparatus.
PERMEABILITY OF SAVCIBEY DAM (BİLECİK) AXIS LOCATION AND DESIGN OF GROUT CURTAIN
Authors:
Mustafa Can CANOĞLU, Bedri KURTULUŞ
ABSTRACT
This study comprise the design of the planned grout curtain in Savcıbey Dam (Söğüt/Bilecik) in order to provide impermeability along the dam axis. Within the context of field studies, engineering geology map was generated, ground investigation drilling was realized and permeability tests were performed. Within the field studies, the joint conditions of the geological units (Triassic aged Bozüyük Metamorphic schists) under the dam axis and its effect on permeability was observed considering the positions of the discontinuities with regard to the dam axis location. Orientation of discontinuities generally have strikes changing between N – S and NNE – SSW. 5 boreholes on dam axis, 2 boreholes on cofferdam, 3 boreholes on diversion tunnel and 2 boreholes on spillway total 245 m ground investigation borehole were drilled. In order to determine the permeability profile of dam axis and design the grout curtain, Lugeon tests in Bozüyük Metamorphic units observed in dam axis, falling head permeability tests in alluviums observed in thalveg and slope debris observed in right abutment were performed. Lugeon tests realized in Bozüyük Metamorphic units show that the unit is generally permeable and partly low permeable. Alluvium and slope debris are highly permeable. In addition, drilling works realized in dam axis shows that the augmentation of the weathering degree cause an increase of permeability in Triassic aged Bozüyük Metamorphic schists. As a result of these studies information about the permeability of Savcıbey Dam was collected and the grout curtain hole was designed. Accordingly, it is predicted that approximately 40 m depth of grout curtain from the stripping excavation with the depth of 1.50 m would prevent the possible leakages
Keywords:
Savcıbey Dam, Lugeon Test, falling head permeability test, design of grout curtain hole
Mohammed Tayeb ABEDGHARS, Mokhtar GHERS, Salah BOUHOUCHE, Belgacem BEZZINA
Indexed In · Volume 162 / 2020
Characterization of iron ore and scale for synthesizing vinyl paint
Authors:
Mohammed Tayeb ABEDGHARS, Mokhtar GHERS, Salah BOUHOUCHE, Belgacem BEZZINA
ABSTRACT
Two materials are studied to synthesize a vinyl painting. Iron ore is an iron pigment with an oolithic structure containing phosphorus. The second material is a steel by-product. The raw materials proprieties were studied by chemical, particle size, thermal, XRD and spectrophotometric analysis. The iron contents of the pigment and scale are respectively 53.18% and 73.83%. The grindability of scale is better than that of the pigment. The particle volume distribution is 0.7 to 32 µm for scale and 0.6 to 40 µm for pigment. TGA and DTA tests show that the pigment loses weight with phase dissolution by consuming energy and the scale gains weight with the formation of a new phase when the temperature increases. The SEM of the scale showed a homogeneous structure of iron oxide grains ranging from 1 to 10 μm. XRD analysis shows that the iron in the pigment is in the form of (Fe2O3) and FeO (OH)) and very little (Fe2SiO4). The iron in the scale is in the form of (FeO, Fe2O3 and Fe3O4). Spectrophotometric tests show that the two materials have no absorption and their reflection is maximum (100%) in the visible range.
https://doi.org/10.19111/bulletinofmre.604081
Oktay CANBAZ, Ahmet GÖKCE, Taner EKİCİ, Hüseyin YILMAZ
Indexed In · Volume 162 / 2020
Geochemical characteristics of the Eocene Karataş volcanics (Northeast Sivas, Turkey) in the İzmir-Ankara-Erzincan Suture Zone
Authors:
Oktay CANBAZ, Ahmet GÖKCE, Taner EKİCİ, Hüseyin YILMAZ
ABSTRACT
Karataş volcanics, is the product of Eocene volcanics crop out in the form of two belts along the northern and southern boundaries of the İzmir-Ankara-Erzincan Suture Zone. According to geochemical data, these volcanics have alkaline basic-intermediate character and consist of basaltic trachyandesite, trachyandesite and trachyte. This volcanic activity has been controlled by fractional crystallization and crustal contamination from basaltic trachyandesite to trachyte. Orientation of the samples towards amphibole area on the Rb/Sr - Ba/Rb ratio diagrams, dispersion of the Zr/Ba ratios (0.08 - 0.33) in the lithospheric mantle range, increase in the Ba/Rb ratio, decreases in the MgO, Ni and Cr contents point out that this volcanism originated from enriched lithospheric mantle rather than asthenospheric mantle. Geochemical data show that this enriched lithospheric mantle material is upper continental crustal material, main part of enrichment resulted by the subduction related fluids and also the contribution of the sedimentary materials. This situation may be explained that; the melts, derived from N-MORB or OIB bearing material ascended into the continental crust in a pre-collisional period and were reactivated by extensional tectonic and/or delamination processes during the post-collisional period, possibly caused the partial melting within the upper continental crust and produced the Karataş volcanics.
https://doi.org/10.19111/bulletinofmre.669717
Characteristic mollusc, larger foraminifera findings and environmental interpretations of the Middle Eocene Kocaçay formation deposits around Ayvalıca (Bayat, Çorum)
Authors:
Müjde GÜRSOY, Muhittin GÖRMÜŞ
ABSTRACT
Although the Çankırı-Çorum Basin was studied for various purposes such as geological, stratigraphical, tectonic, coal and oil exploration, studies on fossils are limited. Especially there have not been detailed studies on molluscs and larger foraminifera. The research area is located at the vicinity of Ayvalıca (north of Çankırı-Çorum basin). The Middle Eocene Kocaçay formation, which outcrops in the Çankırı-Çorum Basin, is widespread around Bayat Çorum in the north of the basin, Sulakyurt Kırıkkale in the west, Çiçekdağı Kırşehir in the south and Sungurlu Çorum in the middle of the basin. The formation is composed of conglomerate, carbonated sandstone, limestone and sandy marls and also includes rich larger foraminifera and molluscs. This study mainly focuses on taxonomy and environmental interpretations of Ostrea roncaensis (Partsch in coll. Bayan, 1870) de Gregorio, 1884, Velates perversus (Gmelin, 1791) species from Mollusca and Nummulites beaumonti d’Archiac and Haime, 1853, N. aturicus Joly and Leymerie,1848, N. perforatus (de Montfort, 1808) and Assilina exponens (Sowerby, 1840) species from larger Foraminifera. In addition, considering faunal features from bottom to top Ostrea roncaensis, Velates perversus, Nummulites aturicus and Assilina exponens Abundance Biozones were identified. The age range of the Kocaçay Formation is determined as Lutetian-Bartonian. Lithological and faunal contents indicate that sediments of the Kocaçay formation were deposited within lagoon to nummulitic sets in a shallow marine environment.
https://doi.org/10.19111/bulletinofmre.685461