In this study, it is aimed to determine safe bearing capacity of soils, which are out cropped around Tamzi and Akcakale villages located in Gumushane, providing allowable settlement conditions for an optimum foundation design. To define the geotechnical properties of soils, three trenches were dug and two seismic refraction with two Multichannel Spectral Analysis of Surface Waves (MASW) were carried out in each research area. Sieve analyses, shear box tests, triaxial compression tests were carried out on disturbed and undisturbed samples taken from the trenches. Seismic velocities of the soils are determined by seismic refraction and MASW methods. While determining the safe bearing capacity; the equations proposed by Terzaghi, Meyerhof, Kurtulus, Tezcan and Ozdemir, Turker, Keceli were used and the obtained safe bearing capacity values were compared to each other. After, the soils were modeled numerically by using finite elements method and safe bearing capacities providing allowable settlement conditions were determined. According to the results, safe bearing capacity values obtained from empirical equations are not satisfactory to have an optimum foundation design. For the optimum foundation design, safe bearing capacity should be accepted as 190 kN/m2 for clayey soil (CL) and 485 kN/m2 for the clayey sand (SC).
Effect of degree of saturation on consolidation parameters of fine-grained soils
Authors:
Deniz YILMAZ, Kamil KAYABALI
ABSTRACT
Terzaghi (1943)’s theory of consolidation phenomenon has some limitations for unsaturated geological environments in nature. Additionally, soils are subjected to consolidation tests under partially saturation conditions. The scope of this study is to illustrate the effect of degree of saturation (Sr) on the consolidation parameters using remolded soil samples. For this purpose, swelling pressure, compression index (cc), re-compression index (cr), coefficient of consolidation (cv), and pre-consolidation stress (σp’) were determined for the samples having different degrees of saturation and plasticity (PI). The consolidation parameters obtained from “undersaturated” remolded samples with varying degrees of saturation were compared with the consolidation parameters obtained from “fully saturated” remolded samples to illustrate which parameters of consolidation are affected most by the degree of saturation. The effect of swelling of partially saturated samples was eliminated prior to conducting oedometer tests. Results indicated a meaningful relationship between the compression index and the degree of saturation, though the relationship with the recompression index was less certain. Pre-consolidation stress generally decreased as saturation increased, while no definitive trend was observed between the degree of saturation and the consolidation coefficient. Overall, most consolidation parameters were found to be somewhat affected by the degree of saturation.
Keywords:
Degree of Saturation, Coefficient of Consolidation, Pre- Consolidation Pressure, Consolidation Parameters, Compression Index, Recompression Index.
Discussion: Determination of Atterberg Limits Using the Vane Shear Test Method [Bull. Min. Res. Exp. (2024) 174: 1–10]
Authors:
Brendan O’KELLY, Amin SOLTANI
ABSTRACT
This article presents a discussion of the original research reported in the paper by Kayabalı et al. (2024) (the Authors) that was recently published in the Bulletin of the Mineral Research and Exploration Vol. 174, pp. 1–10. Using liquid limit (LL), plastic limit (PL) and vane shear strength against water content [i.e., su(VST)–w] results obtained for 100 fine-grained soil samples, the Authors performed multiple regression analyses to produce four strength-based correlations for predicting the LL and PL values based on su(VST)–w measurements. The Authors’ dataset primarily consisted of residual soils formed through the weathering of igneous rocks, along with a few lacustrine soil samples, all sourced from the vicinity of Ankara, Türkiye. This discussion article examines the veracity of the Authors’ claims regarding the predictive performance of their proposed correlations when applied to other fine-grained soils. Using a sizable independent database of dissimilar fine-grained soils compiled from the research literature, it is conclusively shown that, contrary to the Authors’ assertions, their proposed correlations generally produce poor LL and PL predictions when employed beyond the calibration soil types. This outcome is not unexpected, since the Authors’ data-driven correlations were deduced based on a specific dataset with limited diversity in terms of soil physico-chemical and mineralogical attributes. The article closes with a discussion of the plausible explanations for the poor applicability of the Authors’ correlations when apllied to dissimilar fine-grained soils.
Fahmy O. MOHAMMED, Ahmed Ibraheem MOHAMED, Ibrahim H. GART, Diary A . Al-MANMI
Indexed In · Volume 176 / April 2025
Establishing of soil loss tolerance limit and sediment yield in Zagros fold-thrust belt: a case study in the Kanarwe river basin, Iraq-Iran
Authors:
Fahmy O. MOHAMMED, Ahmed Ibraheem MOHAMED, Ibrahim H. GART, Diary A . Al-MANMI
ABSTRACT
Soil degradation is a significant cause of topsoil loss; in most mountainous region watersheds, it leads to decreased agriculture productivity and reservoir storage. This study targeted calculating and mapping soil loss and sediment yield in the Lesser Zab watershed located between Iraq and Iran. The Revised Universal Soil Loss Equation (RUSLE) model was used to calculate the soil loss. A Digital Elevation Model of 30m, a Digital Soil map (1:500000), rainfall, and land cover were used to derive parameters. The soil loss rates are 58.1 and 0.1 tha-1yr-1. The total annual soil loss is 1037289 tonnes, of these 404512, covering 75% of Kanarwe river basin land. Most of these affected lands are in the eastern and middle part, which is below the FAOs standard allowable for tolerable soil erosion. Still, the rest covers 25 % of the basin in the west with a total annual soil loss equal to 632777 tonnes, above FAOs standard. The maximum and minimum sediment yield is 29 and 0.1 tha-1yr-1, respectively. Based on the statistical correlation coefficient, the most effective RUSLE parameters on sediment yield from high to low are topography 0.48, soil erodibility 0.38, and crop management 0.38.
Keywords:
RUSLE, Sediment Delivery, Zagros Thrust Zone, CN-SCS Curve, Dam Lifespan.
Gökhan KADINKIZ, Mustafa KARAKAŞ, Mehmet PEKGÖZ, Abdurrahman MURAT
Indexed In · Volume 154 / 2017
SODIUM SULFATE (GLAUBERITE-BLOEDITE) - HALITE ASSOCIATION İN THE TERTIARY (UPPER MIOSENE - PLIOCENE) KATRANDEDETEPE FORMATION, EREĞLİ-BOR BASIN, TURKEY
Authors:
Gökhan KADINKIZ, Mustafa KARAKAŞ, Mehmet PEKGÖZ, Abdurrahman MURAT
ABSTRACT
This study covers the investigations related to the glauberite-halite minerals detected in Neogene deposits of the Ereğ- li-Bor Basin in the Central Anatolia. The basin consists of Paleozoic basement rocks, the unconformably overlying Paleocene-Eocene-Oligocene marine sedimentary and volcano-sedimentary rocks, and the Lower Miocene-Pliocene lake deposits at the top which unconformably overlie all underlying layers. In the study, core drillings related to the determination of geological characteristics and investigation of the mineral potential of buried salt deposits were carried out in the Ereğli-Bor basin. As a result of drillings carried out, glauberite-bloedite, halite and bituminous shale horizons, which possess significant thickness and grade values, were cut for the first time in the Konya-Ereğli-Bor basin. Glauberite minerals were observed in three different structures as; 1- the Glauberite Mineral intercalated with High Graded, Bedded Clays, 2- the Glauberite Mineral with Disseminated Rosette Type in Low Graded Clays and 3- the Prismatic High Graded Glauberite Mineral intercalated with Halites. Bloedite minerals are mostly observed with halite. It was detected that the economical evaporitic formations in the Konya-Ereğli-Bor Basin had occurred within the Upper Miocene-Pliocene Katrandedetepe formation which represents the playa-lake environment.
INVESTIGATION OF GÜLLÜK (MUĞLA) WETLAND BY STABLE ISOTOPES (δ18O, δD)
Authors:
Melis A. SOMAY
ABSTRACT
Wetlands play an important role in the hydrologic cycle. This investigation was completed to determine the origin of waters and recharge-discharge areas using stable isotopes (δ18O and δD) which are fingerprints of the water in Güllük (Muğla) wetland. This area is important both economically and in terms of aquaculture environment in Turkey. Sample locations were selected from not only wetlands but also the possible recharge area that consists of karstic springs and streams. EC (Electrical Conductivity) of the waters range between 5080-41000 µS/cm, except streams. δ18O and δD contents of the samples ranged from -6.00‰ to 0.50‰ and from -29.1‰ to 2.1‰, respectively. In general, samples plotted between Global and Local Meteoric Water line with waters also plotted on the seawater mixing line. The sources of salinity were evaluated by δ18O-Cl in and around the wetland. Streams are under the influence of “Evaporation”; samples from Avşar and Koruköy are under the influence of “Both Evaporation and Seawater Mixing”; İçme and Ekinambarı springs, and Limni Lake are under the influence of “Seawater Mixing”; and Savran spring and Tuzla Lake are under the influence of “Dissolution of Salts-Leaching” processes. The fact that Savran source plotted in this area raises the question of whether the current sea water is the source of salinity. The recharge area of the wetland consists of karstic formations, sea water, streams and precipitation in the Güllük area.
Keywords:
Güllük, Wetland, Stable Isotope, Salt water intrusion, Hydrogeology
RESPONSE TO THE “REACTION OF THE PHYSICAL TRANSFORMATION OF THE GRAVITY DATA AND LINEARITY DILEMMA”
Authors:
Uğur AKIN
ABSTRACT
There is not any filter such as the “apparent gravity linear filter”, which is mentioned by the criticizer, in the literature of geophysical potential methods.
The “apparent density filter” was used in the study. As the name implies; the crustal structure of Turkey was investigated in the article of “Investigation of the Seismic Velocity Distribution and the Crustal Structure of Turkey” (Akın, 2016). So; the article had different findings. The “Conrad discontinuity” has been one of the findings of this article. Or else; the distribution related to the Conrad discontinuity has not been the main topic of the article as it had been understood by the criticizer. In this study, the density and seismic velocity took their highest values within first 20 km’s of the continental crust as; 2.74 gr/cm³ and 5.86 km/s, respectively. This zone was considered at the same time as the Conrad discontinuity between the lower and upper crusts, and it had an approximate depth of 16 km.
Keywords:
RESPONSE TO THE REACTION OF THE PHYSICAL TRANSFORMATION OF THE GRAVITY DATA AND LINEARITY DILEMMA