BULLETIN OF THE MINERAL RESEARCH AND EXPLORATION (MTA Dergisi)
AUTHOR PROFILE
Articles by Deniz Yılmaz
4 PUBLICATIONS
01
Volume 176 / 2025 · Pages: 154-157
Kamil KAYABALI, Honne NAGARAJ, Deniz YILMAZ, Muhammet BEYHAN
Indexed In · Volume 176 / 2025
Reply to: “Discussion: Determination of Atterberg Limits Using the Vane Shear Test Method [Bull. Min. Res. Exp. (2024) 174: 1–10]”
Authors:
Kamil KAYABALI, Honne NAGARAJ, Deniz YILMAZ, Muhammet BEYHAN
ABSTRACT
The main focus of the criticisms raised by O’Kelly and Soltani (2025) (hereafter referred to as discussers) to the authors’ article in Bulletin of Mineral Research and Exploration (174, 1-10) is to examine the veracity of the strength-based equations presented by Kayabalı et al. (2024). The discussers applied the predictive equations proposed by the authors to dissimilar soils in the two articles (Kayabalı et al., 2015a; Kayabalı et al., 2015b) published earlier by the lead author with his research group. The discussers showed that the predictive equations 6 and 7 given by Kayabalı et al. (2024) yield extremely high values of liquid limit (LL) and plastic limit (PL) when applied to dissimilar soils. Further, discussers argued that the approach proposed
by Kayabalı et al. (2024) led to erroneous results in determining soil classes.
Effect of degree of saturation on consolidation parameters of fine-grained soils
Authors:
Deniz YILMAZ, Kamil KAYABALI
ABSTRACT
Terzaghi (1943)’s theory of consolidation phenomenon has some limitations for unsaturated geological environments in nature. Additionally, soils are subjected to consolidation tests under partially saturation conditions. The scope of this study is to illustrate the effect of degree of saturation (Sr) on the consolidation parameters using remolded soil samples. For this purpose, swelling pressure, compression index (cc), re-compression index (cr), coefficient of consolidation (cv), and pre-consolidation stress (σp’) were determined for the samples having different degrees of saturation and plasticity (PI). The consolidation parameters obtained from “undersaturated” remolded samples with varying degrees of saturation were compared with the consolidation parameters obtained from “fully saturated” remolded samples to illustrate which parameters of consolidation are affected most by the degree of saturation. The effect of swelling of partially saturated samples was eliminated prior to conducting oedometer tests. Results indicated a meaningful relationship between the compression index and the degree of saturation, though the relationship with the recompression index was less certain. Pre-consolidation stress generally decreased as saturation increased, while no definitive trend was observed between the degree of saturation and the consolidation coefficient. Overall, most consolidation parameters were found to be somewhat affected by the degree of saturation.
Keywords:
Degree of Saturation, Coefficient of Consolidation, Pre- Consolidation Pressure, Consolidation Parameters, Compression Index, Recompression Index.
Kamil KAYABALI, H. B. NAGARAJ, Deniz YILMAZ, Muhammed BEYHAN
Indexed In · Volume 174 / 2024
Determination of Atterberg Limits using the vane shear test method
Authors:
Kamil KAYABALI, H. B. NAGARAJ, Deniz YILMAZ, Muhammed BEYHAN
ABSTRACT
Atterberg limits are important index parameters used to classify soils for various engineering applications. Engineering properties of soils are predicted through simple correlations with index properties and thereby the engineering behavior of soils are qualitatively assessed. There are two popular methods of determining liquid limit, and plastic limit is commonly determined adopting rolling thread methods. To avoid operator related variations in determining plastic limit by conventional method, some researchers have explored using cone method as an alternative. However, there is no consensus about the depth of penetration to reckon the end of plastic state. Though various other test methods have been developed to determine plastic limit (like roll plate device), cone penetration with its limitation of determining plastic limit, is the only method to determine both liquid and plastic limit of soils. Since laboratory vane shear test is a simple and reliable method of determining undrained strength of fine-grained soils, the authors have explored to determine both liquid and plastic limits through correlations developed between undrained strength and water content over a range of consistencies between liquid and plastic states. This would eliminate determining liquid and plastic limit separately without sacrificing the reliability of results.
Kamil KAYABALI, Turgay BEYAZ, İlknur KARAASLAN ÖZDEMİR, Deniz YILMAZ
Indexed In · Volume 173 / 2024
A simple and practical tool for indirect determination of the unconfined compressive strength of most common construction materials
Authors:
Kamil KAYABALI, Turgay BEYAZ, İlknur KARAASLAN ÖZDEMİR, Deniz YILMAZ
ABSTRACT
Determination of the unconfined compressive strength (UCS) of construction materials in the laboratory is tedious and time-consuming. There have been many attempts to indirectly predict UCS using simpler tools and techniques. One of them is the nail gun. The scope of this investigation is to design a nailer which can be applied all construction materials whose UCS range from 1-100 MPa. In the research, rocks, bricks, and concretes prepared in different cement/sand ratios with different strength ranges were used as materials. The unconfined compressive strength of the materials used in the experiments was first determined by conventional compression tests. The nail penetration depths were determined by conducting experiments on the same materials using a nailer with two different energy levels. An empirical relationship was developed by using nail penetration depths, driving energies, and nail diameters as the independent variables and the UCS determined by the conventional method as the dependent variable. According to the empirical relationship determined by multiple regression analysis, the UCS of building materials can be estimated with significance level of 99% by the nail penetration method. The research also revealed that the UCS of rocks might have a coefficient of variation as high as 30%.
Keywords:
Compressive strength, building materials, nail gun, driving energy.