Gravity, Free Air, Bouguer, İsostasy, Crust Thickness, Density
Abstract:
In this study, the maps generated from the regional gravity data, which had been measured within scope of “Türkiye Rejyonal Gravite Haritaları Projesi” (Regional Gravity Map of Turkey) project were introduced. The topography, Free Air, Bouguer gravity, isostatic residual, isostatic regional, density and crust thickness maps of Turkey in 1/1 500 000 scale were prepared using database which started in 1973 and ended in 2011. The boundaries of the main tectonic members were determined by crust thickness, isostatic residual and Bouguer gravity maps of Turkey. Within this scope, a database that will illuminate the investigation of crustal structure, the development of the scientific database and the solution of geological problems were established.
Mona FAWZY, Mustafa BAYOUMI, Hassan SHAHIN, Bahaa EMAD, Abdel Hay EL SHAFEY, Marwa ABDEL-AZEEM, Ahmed ISMAIL, Asmaa EL-MOGHAZY, Mohamed DIAB
Indexed In · Volume 174 / August 2024
Economic heavy minerals in the stream sediments of wadi Shaàb, southern coast of the Red Sea, Egypt; characterization and upgrading for investigation of their potential recovery
Authors:
Mona FAWZY, Mustafa BAYOUMI, Hassan SHAHIN, Bahaa EMAD, Abdel Hay EL SHAFEY, Marwa ABDEL-AZEEM, Ahmed ISMAIL, Asmaa EL-MOGHAZY, Mohamed DIAB
ABSTRACT
The southern coast of the Red Sea is one of the most promising areas for the occurrence of economic minerals. Therefore, studying the characterization and evaluation of these minerals in the Wadi Shaàb Quaternary sediments and investigating their ability to concentrate and physically separate using economical and ecofriendly techniques is the main goal of this work. The results showed that the representative sample contains an average of 0.06% ilmenite, 0.08% zircon, 0.07% rutile, 0.07% leucoxene, 0.008% cassiterite, 0.004% xenotime, 0.0004% monazite, 0.022% almandine garnet, and 0.46% magnetite. The recovery of economic heavy minerals was applied using a combination of wet-gravity technique via shaking table and magnetic separation using high intensity magnetic separator. The results demonstrated the success of gravity separation in raising the grade from 7.63% to 45.03% in a yield of 13.74% out of the original sample, and also valuable metallurgical recoveries that higher than 89% for tabling multi-stages (rougher and scavenging) was obtained. Concentrated mineral fractions of magnetite, ilmenite, almandine, heavy silicates, and the nonmagnetic fraction bearing zircon and rutile were obtained using a high intensity magnetic separator at different ampere range.
Keywords:
Heavy Minerals, Red Sea Coast, Gravity Concentration, Magnetic Separation, Potential Recovery, Material Balance.
Modelling and computation of gravitational attraction, gradient tensors, rotational and horizontal invariants of Asteroid Bennu (101955), Itokawa (25143) and Eros (433) via 2D Non-Uniform FFT
Authors:
İlkin ÖZSÖZ
ABSTRACT
The internal structure and mass distribution of the terrestrial objects are yet unknown. The 2D gravity model with a constant density of the terrestrial objects can shed light on the surficial or textural heterogeneity due to topographic variations of the terrestrial objects. Three different steroids, which are Bennu (101955), Itokawa (25143) and Eros (433) are modelled in this study. During the modelling phase, a different number of edges, elements, nodes, and faces are used to describe the 3D models of Bennu, Itokawa, and Eros. These 3D models are used in 2D Non-Uniform Fast Fourier Transform (NU-FFT) applications to obtain gravitational attraction with a constant density polyhedron model. Tensor gradients and tensor invariants of the modelled gravity anomaly are calculated. Three major outcomes are interpreted from tensor gradient and tensor invariants. Firstly, textural heterogeneity due to relatively low topography is detected in the central part of Bennu. Secondly, considerably different properties which can be related to surface variations between the two lobes of Itokawa are observed. Lastly, directional surficial heterogeneities were detected in Eros.
Oya PAMUKÇU, Ayça ÇIRMIK, Fikret DOĞRU, Ece ÜNLÜ, Barış Can MALALİÇİ
Indexed In · Volume 169 / 2022
Assessment of crustal thinning and tectonic stress distribution of Gülbahçe fault zone and its surroundings (İzmir, West Türkiye) using gravity and magnetic anomalies
Authors:
Oya PAMUKÇU, Ayça ÇIRMIK, Fikret DOĞRU, Ece ÜNLÜ, Barış Can MALALİÇİ
ABSTRACT
Gülbahçe Fault Zone (GFZ) is a significant tectonic structure and seismic source for İzmir city and its surroundings. The major earthquakes occurred at the surroundings of GFZ are 2005 Seferihisar, 2020 Samos Island-Aegean Sea and 2021 Seferihisar earthquakes. In this study, the crustal thinning and tectonic stress distribution of GFZ and its surroundings were analyzed by using the new gravity and magnetic data. The correspondence analysis was applied by appraising together the magnetic and free-air anomaly data. Moreover, the average density of the subsurface structure was calculated by applying the Parasnis method. The deviatoric stress calculation was executed and the change of the physical properties that controls the gravity and magnetic anomaly of the crustal structure of the GFZ and its surroundings from north to south was investigated. Therefore, the average density values, which were obtained from gravity anomalies, were computed as 2.59 gr/cm3 in the north of the study region and it decreased to 2.06, 1.8 and 1.49 gr/cm3 towards to the south. The freeair gravity anomaly values were between 0-70 mGal and the magnetic anomalies were between -450-150 nT. The deviatoric stress values were between -0.2-0.1 MPa.
https://doi.org/10.19111/bulletinofmre.1029265
Thanh NGUYEN TİEN, Tuyen VU DANH, Hung TRİNH LE HUNG, Hang NGUYEN THİ LE HANG
Indexed In · Volume 153 / 2016
SPATIAL CLUSTER AND OUTLIER IDENTIFICATION OF GEOCHEMICAL ASSOCIATION OF ELEMENTS: A CASE STUDY IN JUIRUI COPPER MINING AREA
Authors:
Thanh NGUYEN TİEN, Tuyen VU DANH, Hung TRİNH LE HUNG, Hang NGUYEN THİ LE HANG
ABSTRACT
Spatial clusters and spatial outliers play an important role in the study of the spatial distribution patterns of geochemical data. They characterize the fundamental properties of mineralization processes, the spatial distribution of mineral deposits, and ore element concentrations in mineral districts. In this study, a new method for the study of spatial distribution patterns of multivariate data is proposed based on a combination of robust Mahalanobis distance and local Moran’s Ii. In order to construct the spatial matrix, the Moran’s I spatial correlogram was first used to determine the range. The robust Mahalanobis distances were then computed for an association of elements. Finally, local Moran’s Ii statistics was used to measure the degree of spatial association and discover the spatial distribution patterns of associations of Cu, Au, Mo, Ag, Pb, Zn, As, and Sb elements including spatial clusters and spatial outliers. Spatial patterns were analyzed at six different spatial scales (2km, 4 km, 6 km, 8 km, 10 km and 12 km) for both the raw data and Box-Cox transformed data. The results show that identified spatial cluster and spatial outlier areas using local Moran’s Ii and the robust Mahalanobis accord the objective reality and have a good conformity with known deposits in the study area.
Keywords:
Spatial Outliers, Spatial Clusters, Spatial Variability, Local Moran Statistic, Geochemistry
DIAGENETIC HISTORY OF THE ROCK UNITS OF BOZKIR UNIT CONTROLLED BY THE TRIASSIC RIFTING, BOZKIR-KONYA
Authors:
Hüseyin YALÇIN, Ömer BOZKAYA, Mine TAKÇI
ABSTRACT
The Bozkır Unit representing the northern edge of the Taurus Belt. It comprises from bottom to top, three distinct structural entities: the Upper Triassic pre-rift (Korualan Group), the Upper Triassic-Upper Cretaceous syn-rift (Huğlu Group) and the Jurassic-Cretaceous Boyalı Tepe Group as to their structural settings. The Korualan Group is represented by the alternations of carbonate (limestone, dolomitic limestone, dolomite) with radiolarite and chert intercalations and clastic rocks (sandstone, siltstone, mudstone, shale). The Huğlu Group is made up of volcanic (basalt, andesite) and pyroclastic (tuffaceous sandstone) rocks including radyolarite, limestone and clastic rock (sandstone, siltstone, shale) intercalations. The Boyalı Tepe Group is completely made of carbonate rocks. The carbonate-silisiclastic-volcanogenic rocks of the Bozkır Unit contain carbonate (calcite, dolomite), quartz, feldspar (plagioclase, anortoclase), phyllosilicate (illite, chlorite, mixed-layered illite-chlorite / I-C, chlorite-vermiculite / C-V, chlorite-smectite / C-S, rarely smectite), augite, hematite, analcime and heulandite in order of abundance. On the basis of illite Kübler Index data; Korualan Group and Huğlu Group reflect low grade diagenetic, high grade diagenetic and high grade diagenetic-anchizonal characteristics, respectively. The illite/micas of the pre-rift units and units related to the rifting have muscovitic, and phengitic and seladonitic compositions, respectively. The distributions of chondrite-normalized trace and rare earth element (REE) contents in the illites present similar trends for Korulan ve Huğlu groups, but the quantities of these elements slightly increase in the Huğlu Group. d18O–dD isotopic compositions of water forming the illite minerals are different than that of sea water and found to be between Eastern Mediterranean Meteoric Water (EMMW) and magmatic water compositions. It also shows that temperature of the water forming the illite minerals varies from low to high values. The findings from the rocks of Bozkır Unit suggest that pre- and syn-rift units have different mineralogical-petrographical and geochemical properties. The younger units within the rift due to extension and crustal thinning related to rifting must have exposed in higher diagenetic conditions by more burial and heat with respect to older units at the edges.
Keywords:
Taurus Belt, Extensional Basin, Phyllosilicate, Mineralogy and Geochemistry
UPPER CRETACEOUS-TERTIARY GEOLOGY/STRATIGRAPHY OF PERTEK AND ITS VICINITY (TUNCELİ, TURKEY)
Authors:
Erdal HERECE, Şükrü ACAR
ABSTRACT
The basement units of the studied region are Paleozoic-Mesozoic Keban metamorphic and Upper Cretaceous Elazığ magmatics. As a result of tectonic events caused by final collision in Middle Maastrichtian, all these basement units were juxtaposed, uplifted, eroded and acted as source areas for the Upper Cretaceous-Paleogene basins. Upper Cretaceous-Paleogene units were sampled systematically in order to determine their ages and lithologies. These marine units were identified as Harami, Seske and Kırkgeçit formations based on new age data and their stratigraphic positions. Other units of the study area are Upper Oligocene-Lower Miocene Alibonca formation and Pliyosen Karabakır formation. Harami formation, late Maastrictian-Thanetian in age, comprises grainstone with sandstone intercalation at the base and white colored marble-like limestone at the upper part. Seske formation late Cuisian - early middle Lutetian aged consists of pebblestone, including pebbles from Elazığ magmatics and Harami formation. The upper part of the unit comprises carbonate cemented sandstone with plenty of nummulites and ophiolitic fragments. Kırkgeçit formation, early Bartonian-early Chattian in age, comprises sandstone-siltstone-limestone intercalation. Alibonca formation, Late Oligocene-Early Miocene in age, consists of pebblestone at the lowest part, reefal limestone in the middle and clayey limestone with limestone interlayers in the upper part of the sequence. Karabakır formation is consists of pebblestone-mudstone and locally pyroclastic rocks and lava intercalations. Volcanites comprise basalt with sedimentary interbeds and pyroclastics. It has lateral and vertical transitions with the sedimantary lithologies of Karabakır formation. There are no data to date the formation; however, based on its stratigraphical position and its lateral equivalents, it is assumed to be Pliocene. In the studied area, macrotectonic events were experienced during the Maastrictian, Early Eocene, Middle Eocene (middle-upper Lutetian), Middle Oligocene, Middle?-Upper Miocene and Latest Pliocene. During the last deformation phase, the Anatolian plate began moving westward which is bounded in the E.SE by the East Anatolin Fault. In the study area Pertek fault started to move as a rigth-lateral strike-slip fault.