Gravity, East Mediterranean, Cyprus Arc, Antalya Arc.
Abstract:
Tectonic structures in the Black Sea and the Levantine Sea were mapped using satellite gravity data. The relationship between Antalya and Cyprus arcs is revealed by the deformation traces of the arc formation. The Cyprus arc which over the slice that disappears from the South of the Anaximander seamounts to the Northeast, can traceable at the western end of the Antalya Bay. The distinction of western and eastern basins in the Black Sea is also mapped. Due to the low spatial resolution, additional studies with higher resolution are required.
Mona FAWZY, Mustafa BAYOUMI, Hassan SHAHIN, Bahaa EMAD, Abdel Hay EL SHAFEY, Marwa ABDEL-AZEEM, Ahmed ISMAIL, Asmaa EL-MOGHAZY, Mohamed DIAB
Indexed In · Volume 174 / August 2024
Economic heavy minerals in the stream sediments of wadi Shaàb, southern coast of the Red Sea, Egypt; characterization and upgrading for investigation of their potential recovery
Authors:
Mona FAWZY, Mustafa BAYOUMI, Hassan SHAHIN, Bahaa EMAD, Abdel Hay EL SHAFEY, Marwa ABDEL-AZEEM, Ahmed ISMAIL, Asmaa EL-MOGHAZY, Mohamed DIAB
ABSTRACT
The southern coast of the Red Sea is one of the most promising areas for the occurrence of economic minerals. Therefore, studying the characterization and evaluation of these minerals in the Wadi Shaàb Quaternary sediments and investigating their ability to concentrate and physically separate using economical and ecofriendly techniques is the main goal of this work. The results showed that the representative sample contains an average of 0.06% ilmenite, 0.08% zircon, 0.07% rutile, 0.07% leucoxene, 0.008% cassiterite, 0.004% xenotime, 0.0004% monazite, 0.022% almandine garnet, and 0.46% magnetite. The recovery of economic heavy minerals was applied using a combination of wet-gravity technique via shaking table and magnetic separation using high intensity magnetic separator. The results demonstrated the success of gravity separation in raising the grade from 7.63% to 45.03% in a yield of 13.74% out of the original sample, and also valuable metallurgical recoveries that higher than 89% for tabling multi-stages (rougher and scavenging) was obtained. Concentrated mineral fractions of magnetite, ilmenite, almandine, heavy silicates, and the nonmagnetic fraction bearing zircon and rutile were obtained using a high intensity magnetic separator at different ampere range.
Keywords:
Heavy Minerals, Red Sea Coast, Gravity Concentration, Magnetic Separation, Potential Recovery, Material Balance.
Modelling and computation of gravitational attraction, gradient tensors, rotational and horizontal invariants of Asteroid Bennu (101955), Itokawa (25143) and Eros (433) via 2D Non-Uniform FFT
Authors:
İlkin ÖZSÖZ
ABSTRACT
The internal structure and mass distribution of the terrestrial objects are yet unknown. The 2D gravity model with a constant density of the terrestrial objects can shed light on the surficial or textural heterogeneity due to topographic variations of the terrestrial objects. Three different steroids, which are Bennu (101955), Itokawa (25143) and Eros (433) are modelled in this study. During the modelling phase, a different number of edges, elements, nodes, and faces are used to describe the 3D models of Bennu, Itokawa, and Eros. These 3D models are used in 2D Non-Uniform Fast Fourier Transform (NU-FFT) applications to obtain gravitational attraction with a constant density polyhedron model. Tensor gradients and tensor invariants of the modelled gravity anomaly are calculated. Three major outcomes are interpreted from tensor gradient and tensor invariants. Firstly, textural heterogeneity due to relatively low topography is detected in the central part of Bennu. Secondly, considerably different properties which can be related to surface variations between the two lobes of Itokawa are observed. Lastly, directional surficial heterogeneities were detected in Eros.
Oya PAMUKÇU, Ayça ÇIRMIK, Fikret DOĞRU, Ece ÜNLÜ, Barış Can MALALİÇİ
Indexed In · Volume 169 / 2022
Assessment of crustal thinning and tectonic stress distribution of Gülbahçe fault zone and its surroundings (İzmir, West Türkiye) using gravity and magnetic anomalies
Authors:
Oya PAMUKÇU, Ayça ÇIRMIK, Fikret DOĞRU, Ece ÜNLÜ, Barış Can MALALİÇİ
ABSTRACT
Gülbahçe Fault Zone (GFZ) is a significant tectonic structure and seismic source for İzmir city and its surroundings. The major earthquakes occurred at the surroundings of GFZ are 2005 Seferihisar, 2020 Samos Island-Aegean Sea and 2021 Seferihisar earthquakes. In this study, the crustal thinning and tectonic stress distribution of GFZ and its surroundings were analyzed by using the new gravity and magnetic data. The correspondence analysis was applied by appraising together the magnetic and free-air anomaly data. Moreover, the average density of the subsurface structure was calculated by applying the Parasnis method. The deviatoric stress calculation was executed and the change of the physical properties that controls the gravity and magnetic anomaly of the crustal structure of the GFZ and its surroundings from north to south was investigated. Therefore, the average density values, which were obtained from gravity anomalies, were computed as 2.59 gr/cm3 in the north of the study region and it decreased to 2.06, 1.8 and 1.49 gr/cm3 towards to the south. The freeair gravity anomaly values were between 0-70 mGal and the magnetic anomalies were between -450-150 nT. The deviatoric stress values were between -0.2-0.1 MPa.
https://doi.org/10.19111/bulletinofmre.1029265
Engin MERİÇ, M. Baki YOKEŞ, İpek F. BARUT, Atike NAZİK, Mustafa ERYILMAZ, Fulya YÜCESOY ERYILMAZ, M. Fatih HÜSEYİNOĞLU, Mustafa KUMRAL, Erol SARI
Indexed In · Volume 166 / 2021
Alien foraminifers of the northern and northeastern coastlines of Cyprus Island
Authors:
Engin MERİÇ, M. Baki YOKEŞ, İpek F. BARUT, Atike NAZİK, Mustafa ERYILMAZ, Fulya YÜCESOY ERYILMAZ, M. Fatih HÜSEYİNOĞLU, Mustafa KUMRAL, Erol SARI
ABSTRACT
The study area covers the northern coasts of Cyprus from the Güzelyurt Gulf to the Gazimağusa Gulf. This study was carried out in order to reveal the presence of the alien foraminifera, which are widely distributed in the Eastern Mediterranean particularly Amphistegina lobifera in the study area, and the effects of trace elements on faunal assemblages (foraminifera, ostracod and mollusc). The bottom sediment samples were taken from eighteen different points and depths, the faunal assemblages were examined, and the sediment distribution map of the studied area was made by ICP-MS analysis and geochemical evaluations. 30 genera and 48 species of foraminifera have been identified, of which 9 species belonging to 6 genera are the alien foraminifera. These are: Spiroloculina angulosa, S. antillarum, Hauerina diversa, Coscinospira hemprichii, Peneroplis pertusus, P. planatus, Amphisorus hemprichii, Sorites orbiculus and Amphistegina lobifera. Amphistegina lobifera was observed to be abnormally abundant in most of the samples. This foraminiferal assemblage of Red Sea origin constitutes a poor assemblage compared to the alien assemblages in Turkish Mediterranean coastal areas. It has been determined that the ostracod and mollusc genera and species found in the same samples belong to the typical Mediterranean and Aegean Sea community.
https://doi.org/10.19111/bulletinofmre.838609
The relationship between seismic quality factor and peak ground acceleration, a case study: M=4.3, 17.01.2015 Eskişehir Earthquake
Authors:
Muammer TÜN
ABSTRACT
Seismic wave propagation in subsurface media endures from absorption, which can be evaluated by the seismic quality factor Q (Q-factor). Absorption is frequency-dependent. Lower frequencies are absorbed less, while higher frequencies are absorbed more. Therefore, the Q Factor should be determined in the frequency domain. Q-factor is determined by the slope of the natural logarithm of the output-input signals ratio. Surface waves (Rayleigh and Love waves) are particularly important, as they are the more destructive phases of an earthquake. This study was, focused on the Q-factor computation of the surface waves and demonstrated that the determination of the Q-factor is not affected from the dispersive properties of the surface waves. Data were obtained from surface wave signals of earthquake recorded at Eskişehir Technical University Seismic Network - EstuNet. The obtained Q-factor values represent the average values of the rocks that the waves cross between the input and output stations. Finally, the Q-factor map to the Peak Ground Acceleration (PGA) map using the M=4.3, 17.01.2015 Eskişehir earthquake data was compared. These records show the arrival time of the earthquake from the epicenter to the stations of the seismic waves, and the peak ground acceleration values. In this study, local site effects of EstuNet accelerometric stations have been calculated by using the Standard Spectral Ratio (SSR) method. It is concluded that an inverse relationship exists between the computed Q-factor and measured PGA values. Therefore, the sites where the Q factor is very low should be analyzed in more detail in ground-based earthquake risk assessments.
https://doi.org/10.19111/bulletinofmre.841785
Active tectonics of Gülpınar-Tuzla area (Biga Peninsula, NW Turkey): the source of 6 February-24 March 2017 earthquake cluster
Authors:
Ali KOÇYİĞİT, Şule GÜRBOĞA
ABSTRACT
The variation in the motion sense of Anatolian platelet in Aegean Sea resulted in a strike-slip tectonic regime and related neotectonic domain, the central to northern Aegean neotectonic province, which also includes both western Marmara Sea and Biga Peninsula. Our study focuses mostly on the Gülpınar-Tuzla earthquake area located at the southwestern tip of Biga Peninsula,which is controlled by the southern major strand of the North Anatolian Fault System (NAFS). The strand consists of two sections, the onshore Biga and offshore Babakale-Skyros sections. Both sections are seismically very active. The Gülpınar-Tuzla earthquake area is composed of the Paleozoic metamorphic rocks, the Oligo-Miocene granitoid pluton, Lower-Middle Miocene calcalkalic volcanic rocks and the Upper Miocene-Pliocene sedimentary sequence. All of these rocks, which formed and deformed (folded to tilted) in palaeotectonic period, are overlain with an angular unconformity by the Quaternary neotectonic basin fill, that is nearly flat-lying except for the faulted basin margins. Both the onshore and offshore sections of the southern strand are linked to each other in terms of the structures characterizing the Babakale pull-apart basin and the Gülpınar-Tuzla earthquake area. The latter is shaped by the NE-trending Gülpınar (GFZ) and Yenice-Gönen Fault Zone (YGFZ), the ENE-trending Edremit fault zone (EFZ), the WNW-trending Tuzla Fault Zone (TFZ) and three strike-slip basins (Ayvacık, Behramkale and Tuzla basins) developed along them. Some segments of both the TFZ and GFZ were reactivated by the occurrences of seven moderate-to small-sized independent earthquakes and related aftershocks over 2760. Five of the independent earthquakes have an origin of oblique-slip normal faulting, while the rest two seismic events are strike-slip faulting in origin. Focal mechanism solution diagrams of these two groups of earthquakes reveal that the Gülpınar-Tuzla area is under the control of a strike-slip neotectonic regime, which commenced in Early Quaternary time owing to the major inversion in extensional palaeotectonic regime. This is also supported by the palaeostress analysis of slip-plane data measured on fault slickensides. The uniform slip rates on both the YGFZ and EFZ are 10.8 mm/yr and 7.3 mm/yr, respectively.
https://doi.org/10.19111/bulletinofmre.984922
Keywords:
Active Tectonics, Recent Seismicity, Southern Major Strand, NAFS, Biga Peninsula.