In this paper, two modeling method are employed. First, a method based on the Marquardt’s algorithm is presented to invert the gravity anomaly due to a finite vertical cylinder source. The inversion outputs are the depth to top and bottom, and radius parameters. Second, Forced Neural Networks (FNN) for interpreting the gravity field as try to fit the computed gravity in accordance with the estimated subsurface density distribution to the observed gravity. To evaluate the ability of the methods, those are employed for analyzing the gravity anomalies from assumed models with different initial parameters as the satisfactory results were achieved. We have also applied these approaches for inverse modeling the gravity anomaly due to a Chromite deposit mass, situated east of Sabzevar, Iran. The interpretation of the real gravity data using both methods yielded almost the same results.
Mona FAWZY, Mustafa BAYOUMI, Hassan SHAHIN, Bahaa EMAD, Abdel Hay EL SHAFEY, Marwa ABDEL-AZEEM, Ahmed ISMAIL, Asmaa EL-MOGHAZY, Mohamed DIAB
Indexed In · Volume 174 / August 2024
Economic heavy minerals in the stream sediments of wadi Shaàb, southern coast of the Red Sea, Egypt; characterization and upgrading for investigation of their potential recovery
Authors:
Mona FAWZY, Mustafa BAYOUMI, Hassan SHAHIN, Bahaa EMAD, Abdel Hay EL SHAFEY, Marwa ABDEL-AZEEM, Ahmed ISMAIL, Asmaa EL-MOGHAZY, Mohamed DIAB
ABSTRACT
The southern coast of the Red Sea is one of the most promising areas for the occurrence of economic minerals. Therefore, studying the characterization and evaluation of these minerals in the Wadi Shaàb Quaternary sediments and investigating their ability to concentrate and physically separate using economical and ecofriendly techniques is the main goal of this work. The results showed that the representative sample contains an average of 0.06% ilmenite, 0.08% zircon, 0.07% rutile, 0.07% leucoxene, 0.008% cassiterite, 0.004% xenotime, 0.0004% monazite, 0.022% almandine garnet, and 0.46% magnetite. The recovery of economic heavy minerals was applied using a combination of wet-gravity technique via shaking table and magnetic separation using high intensity magnetic separator. The results demonstrated the success of gravity separation in raising the grade from 7.63% to 45.03% in a yield of 13.74% out of the original sample, and also valuable metallurgical recoveries that higher than 89% for tabling multi-stages (rougher and scavenging) was obtained. Concentrated mineral fractions of magnetite, ilmenite, almandine, heavy silicates, and the nonmagnetic fraction bearing zircon and rutile were obtained using a high intensity magnetic separator at different ampere range.
Keywords:
Heavy Minerals, Red Sea Coast, Gravity Concentration, Magnetic Separation, Potential Recovery, Material Balance.
Modelling and computation of gravitational attraction, gradient tensors, rotational and horizontal invariants of Asteroid Bennu (101955), Itokawa (25143) and Eros (433) via 2D Non-Uniform FFT
Authors:
İlkin ÖZSÖZ
ABSTRACT
The internal structure and mass distribution of the terrestrial objects are yet unknown. The 2D gravity model with a constant density of the terrestrial objects can shed light on the surficial or textural heterogeneity due to topographic variations of the terrestrial objects. Three different steroids, which are Bennu (101955), Itokawa (25143) and Eros (433) are modelled in this study. During the modelling phase, a different number of edges, elements, nodes, and faces are used to describe the 3D models of Bennu, Itokawa, and Eros. These 3D models are used in 2D Non-Uniform Fast Fourier Transform (NU-FFT) applications to obtain gravitational attraction with a constant density polyhedron model. Tensor gradients and tensor invariants of the modelled gravity anomaly are calculated. Three major outcomes are interpreted from tensor gradient and tensor invariants. Firstly, textural heterogeneity due to relatively low topography is detected in the central part of Bennu. Secondly, considerably different properties which can be related to surface variations between the two lobes of Itokawa are observed. Lastly, directional surficial heterogeneities were detected in Eros.
Oya PAMUKÇU, Ayça ÇIRMIK, Fikret DOĞRU, Ece ÜNLÜ, Barış Can MALALİÇİ
Indexed In · Volume 169 / 2022
Assessment of crustal thinning and tectonic stress distribution of Gülbahçe fault zone and its surroundings (İzmir, West Türkiye) using gravity and magnetic anomalies
Authors:
Oya PAMUKÇU, Ayça ÇIRMIK, Fikret DOĞRU, Ece ÜNLÜ, Barış Can MALALİÇİ
ABSTRACT
Gülbahçe Fault Zone (GFZ) is a significant tectonic structure and seismic source for İzmir city and its surroundings. The major earthquakes occurred at the surroundings of GFZ are 2005 Seferihisar, 2020 Samos Island-Aegean Sea and 2021 Seferihisar earthquakes. In this study, the crustal thinning and tectonic stress distribution of GFZ and its surroundings were analyzed by using the new gravity and magnetic data. The correspondence analysis was applied by appraising together the magnetic and free-air anomaly data. Moreover, the average density of the subsurface structure was calculated by applying the Parasnis method. The deviatoric stress calculation was executed and the change of the physical properties that controls the gravity and magnetic anomaly of the crustal structure of the GFZ and its surroundings from north to south was investigated. Therefore, the average density values, which were obtained from gravity anomalies, were computed as 2.59 gr/cm3 in the north of the study region and it decreased to 2.06, 1.8 and 1.49 gr/cm3 towards to the south. The freeair gravity anomaly values were between 0-70 mGal and the magnetic anomalies were between -450-150 nT. The deviatoric stress values were between -0.2-0.1 MPa.
https://doi.org/10.19111/bulletinofmre.1029265
Deniz TİRİNGA, Bülent ATEŞÇİ, Yılmaz ÇELİK, Güvenç DEMİRKIRAN, Cahit DÖNMEZ, Aytekin TÜRKEL, Taner ÜNLÜ
Indexed In · Volume 161 / 2020
Geology and formation of Nevruztepe Fe-Cu skarn mineralization (Kayseri-Turkey)
Authors:
Deniz TİRİNGA, Bülent ATEŞÇİ, Yılmaz ÇELİK, Güvenç DEMİRKIRAN, Cahit DÖNMEZ, Aytekin TÜRKEL, Taner ÜNLÜ
ABSTRACT
The Nevruztepe iron-copper prospect is a skarn near Yeşilhisar (Kayseri). It has been overlooked as a potential producer of copper. The skarn was generated in Permian to Jurassic carbonate rocks by the Eocene Yahyalı granitic pluton. Lithologic units, including skarns, dip about 15 degrees southward. Skarns are both prograde (garnet and diopside) and retrograde (epidote); both exoskarn and endoskarn exist. Most of the magnetite is in a quartz-sulfide stage in retrograde skarn that is cut by veins and lenses containing quartz-pyrite-chalcopyrite. Granite and mineralized skarn are rare at the surface. From 2013 to 2015, 31 drill holes (totaling 6.178,5 m) encountered skarn to a depth of 450 m. Mineralized zones vary from 1,2 to 54,7 m thick. Fe mean grade ranges from 12% to 49%; mean copper grades vary from 10 to 4650 ppm. The deposit contains 5.096.788 tonnes of mineralized material. Microscopy on samples of drill core shows that the ore minerals are primarily magnetite, hematite, and chalcopyrite. Some magnetite is altered to hematite. Experiments show that with grinding to 100 microns the iron can be beneficiated to 66%. Waste from separation of the magnetite is 0.16 to 0.19% Cu; with flotation this was beneficiated to 19% Cu.
https://doi.org/10.19111/bulletinofmre.543189
Muhittin GÖRMÜŞ, Yusuf Kağan KADIOĞLU, Baki Erdoğan VAROL, Muhammed Sami US
Indexed In · Volume 161 / 2020
Early Miocene seed like plant remain fossils and facies associations from the Nallıhan district (NW Turkey)
Authors:
Muhittin GÖRMÜŞ, Yusuf Kağan KADIOĞLU, Baki Erdoğan VAROL, Muhammed Sami US
ABSTRACT
Seed like fossils recognized by their distinctive orbicular in shape are seen in the early Miocene of the Nallıhan area (NW Türkiye). We examined more than one hundred specimens and facies associations for interpreting of fossil morphology and its paleoenvironment. The fossils as dark crystallized dots on the bedding surface of clayey limestones are characterized by a thick edged lenticular shape with a smooth one side and concave another side with circular nucleus. Their internal structures have circular a few whorlings, too often radial calcitic lamellae on the upper side and a few circular coiling at the bottom side. SEM, EPMA and RAMAN data of soft nucleus, hard part, filling materials and surrounding sediments support its plant origin. The Paleogene aged Kızılbayır formation and early Miocene aged Karadoruk and Akpınar formations include the following facieses: non-channelized red sandstone and mudstone (F1), channelized “confined” reddish-beige pebbly sandstone and conglomerate (F2), medium to coarse siliciclastics (F3), mudstones interbedded with sandstones (F4), thin bedded clayey limestone bearing plant fossils (F5) medium to thick bedded limestone (F6) and rhythmic siliciclastics - clayey limestone including coal occurrences (F7). Abundant plant fossils indicate a planted shallow lake margin with low topography during the early Miocene.
https://doi.org/10.19111/bulletinofmre.609697
Determination of the origin and recharge process of water resources in Salda Lake Basin by using the environmental, tritium and radiocarbon isotopes (Burdur/Turkey)
The Salda Lake basin which is in the southwestern Turkey is an important water body in view of environmental values. We used stable isotopes (δD and δ18O), δ3H and 14C composition of the water samples to understand recharge process effective in the groundwater and lake water. Water samples were collected in dry and wet periods and the stable isotope (δD and δ18O) and radiogenic isotope (14C) analysis were made in the basin. The δ18O contents of groundwater and lake water ranged from -9,94‰ to 1,18‰ in dry period and from -10,24‰ to 0,30‰, in wet period. δD contents of groundwater and lake water varied from -67,42‰ to 1,20‰ and from -64,51‰ to -2,80‰, in dry and period wet respectively. The stable isotope data of samples indicate a meteoric origin for all samples. According to stable isotope data, groundwater samples seem to be recharged from higher elevations whereas the lake water is recharged from low elevations. The tritium (δ3H) content of the water samples ranges from 1.04 to 4.49 TU and from 1.91 to 4.18 TU in the dry period and wet period respectively. Long-term δ3H observations are required to determine whether these δ3H signals are associated with young recharge or with the groundwater with long residence time. In addition, the 14C activities of the samples vary between 90 pmc and 110 pmc for Salda Lake waters and 530 pmc and 5990 pmc for the groundwater.
https://doi.org/10.19111/bulletinofmre.604352