Low grade iron ore, Gravity concentration, Magnetic separation, Flowsheet development
Abstract:
In the present study a detailed characterization followed by beneficiation of low grade iron ore was studied. The Run of Mine (R.O.M) sample assayed 21.91 % Fe, which is very low grade in nature. The impurities are SiO2 26.25%, MgO 20.48%, CaO 5.85%, Al2O3 1.86% and loss on ignition (LOI) 12.71%. A Davis Tube test was performed for the assessment of the separability of magnetic ores by low intensity magnetic separators. The heavy liquid test was carried out to evaluate the possible response of the sample by the gravity concentration technique. The samples were subjected to jigging, dry low intensity magnetic separation (DLIMS) and shaking table tests. Thus a sufficient concentrate could not be obtained in +1 mm by using jigging and DLIMS. The obtained results show that the a high grade iron concentrate (>65% Fe) with lower recoveries was obtained from shaking table tests by using -1 mm fraction. According to the results a flowsheet was developed. From the developed flowsheet, it is possible to obtain pellet grade concentrate with 65.41% Fe, 2.54% SiO2, 2.79% MgO, 0.70% CaO and 0.32% Al2O3. with 21.42% weight recovery. The overall gangue rejection recovery of the circuit is over 95%.
Gökhan DEMİRELA, Mustafa Haydar TERZİ, Ahmet Fatih OSKAY
Indexed In · Volume 178 / December 2025
Pegmatites and alkali feldspar granites as sources of industrial K-feldspar: A study from Borucu, Aksaray, Central Türkiye
Authors:
Gökhan DEMİRELA, Mustafa Haydar TERZİ, Ahmet Fatih OSKAY
ABSTRACT
The Borucu (Aksaray) region, within the Central Anatolian Crystalline Complex, comprises a variety of rocks, including granite, alkali feldspar granite (AFG), pegmatite, and aplite dikes. The granite and AFG host some veins or lenses of pegmatites, with lengths reaching approximately 70 m in the N10-25W direction. The AFG and pegmatitic rocks are characterized by variable mineral assemblages, including K-feldspar (orthoclase), quartz, plagioclase, and to a lesser extent, biotite, garnet, and opaque minerals. Inner zones feature the mega-grained pegmatite, whereas outer zones consist of the coarse-grained K-feldspar and quartz pegmatite. In this study, integrated surface and vertical (trenching and drilling) exploration, mineralogy-petrography, geochemical, and magnetic separation analyses were employed to assess the industrial raw material potential of the AFG and pegmatites. The total alkali (Na2O+K2O) contents reach 15.56-16.82% for the mega-grained pegmatite, 8.07-9.76% in the coarse-grained pegmatite, and 9.20-9.66% in the AFG. However, the Fe2O3 contents (0.30-1.15%) constrain their industrial raw material quality. Magnetic separation improved the AFG material to second-quality ceramic industry standards. Despite Fe2O3 limitations, Borucu’s pegmatites and AFG represent usable industrial raw material resources.
Keywords:
Alkali Feldspar Granite, Pegmatite, K-Feldspar, Magnetic Separation.
Mona FAWZY, Mustafa BAYOUMI, Hassan SHAHIN, Bahaa EMAD, Abdel Hay EL SHAFEY, Marwa ABDEL-AZEEM, Ahmed ISMAIL, Asmaa EL-MOGHAZY, Mohamed DIAB
Indexed In · Volume 174 / August 2024
Economic heavy minerals in the stream sediments of wadi Shaàb, southern coast of the Red Sea, Egypt; characterization and upgrading for investigation of their potential recovery
Authors:
Mona FAWZY, Mustafa BAYOUMI, Hassan SHAHIN, Bahaa EMAD, Abdel Hay EL SHAFEY, Marwa ABDEL-AZEEM, Ahmed ISMAIL, Asmaa EL-MOGHAZY, Mohamed DIAB
ABSTRACT
The southern coast of the Red Sea is one of the most promising areas for the occurrence of economic minerals. Therefore, studying the characterization and evaluation of these minerals in the Wadi Shaàb Quaternary sediments and investigating their ability to concentrate and physically separate using economical and ecofriendly techniques is the main goal of this work. The results showed that the representative sample contains an average of 0.06% ilmenite, 0.08% zircon, 0.07% rutile, 0.07% leucoxene, 0.008% cassiterite, 0.004% xenotime, 0.0004% monazite, 0.022% almandine garnet, and 0.46% magnetite. The recovery of economic heavy minerals was applied using a combination of wet-gravity technique via shaking table and magnetic separation using high intensity magnetic separator. The results demonstrated the success of gravity separation in raising the grade from 7.63% to 45.03% in a yield of 13.74% out of the original sample, and also valuable metallurgical recoveries that higher than 89% for tabling multi-stages (rougher and scavenging) was obtained. Concentrated mineral fractions of magnetite, ilmenite, almandine, heavy silicates, and the nonmagnetic fraction bearing zircon and rutile were obtained using a high intensity magnetic separator at different ampere range.
Keywords:
Heavy Minerals, Red Sea Coast, Gravity Concentration, Magnetic Separation, Potential Recovery, Material Balance.
Separation efficiency of different methods in treatment of a low-grade iron ore
Authors:
Özgür ÖZCAN
ABSTRACT
In the present study, characterization and beneficiation tests were performed on an iron ore sample for the evaluation of separation efficiency (SE) of different methods. Results showed that the decrease in feed size fraction increases the SE irrespective of to beneficiation method. It was determined from the liberation analyses that the increase in SE values at finer size fractions is related with higher liberation. Calculated SE values revealed that operational parameters significantly affect the SE of all methods and the net forces acting on particles play an important role on SE of different size fractions. Mean SE of different size fractions showed that the separation efficiencies of gravity concentration and magnetic separation takes similar values above 1 mm, however, SE of magnetic separation is significantly higher than gravity concentration below 1 mm for the studied sample. For low grade ores, it is very crucial to develop a flow sheet to achieve the optimum grade and recovery while decreasing the cost likely by using optimum method. Therefore, SE calculations used in this research can be used as a basic method to compare the efficiency of different beneficiation methods. SE method has advantages as they provide fast evaluation of efficiency by using experimental results.
Keywords:
Separation Efficiency Grade, Recovery, Magnetic Separation, Gravity Concentration.
Geological properties of Güney formation (Ereğli - Ulukışla Basin, Niğde)
Authors:
Ayfer ÖZDEMİR, Nurettin SONEL
ABSTRACT
The aim of this study to determine stratigraphic, sedimentological and petrographic characteristics of the Upper Paleocene - Lower Eocene Güney formation in the Ereğli - Ulukışla Basin based on the lithological and environmental interpretations related to petroleum source and reservoir rock properties of it. For this purpose, the geological characteristics of the Güney formation and its relations with other units were followed by field observations and the unit was investigated by making a stratigraphic cross section from bottom to top. In addition, during the field studies, four (4) scaled stratigraphic sections (OSK) were formed and fifty - two (52) sandstone samples were taken from these OSKs. The Güney formation starts with conglomerates at the basement and continues as sandstone - shale alternation. The fact that the sand size material is more than the clay size material, the sandstone layers are thick (at least 2 m) around the Kardeşgediği station, the presence of channel fillings, slump structures, and pebbles indicate that the sequence shows convergent turbidite character. However, in the vicinity of Ovacık - Güney village and Tatlıpınar ridges, shales having an average layer thickness of 30 cm (thick) and sandstones up to 3 - 5 cm (thin) and shales are denser than sandstones show the formation has divergent character. The Güney formation transitions laterally and vertically overlies the agglomerate unit of the Ulukışla formation and turbiditic sandstone - shale units of the Halkapınar formation. The Aktoprak formation passes laterally and vertically over the Formation. Petrographic studies show that the formation sandstones are lithic arenite and feldspathic arenite and are deposited in the fore - arc basin.
https://doi.org/10.19111/bulletinofmre.855696
Keywords:
Ereğli - Ulukışla Basin, Güney Formation, Sandstone, Sedimantology, Stratigraphy, Petrography
The effect of urban heat island on groundwater located in shallow aquifers of Kütahya city center and shallow geothermal energy potential of the region, Turkey
Authors:
Ali Samet ÖNGEN, Zeynel Abidin ERGÜLER
ABSTRACT
As a result of urbanization, natural surfaces are replaced by artificial surfaces that trap heat such as buildings, pavements and asphalt, so residential areas have higher temperature values than rural areas. This effect, defined as the urban heat island, causes an increase not only in air temperature but also in the subsurface and groundwater. Groundwater temperature values were measured during one year in an area approximately 53 km2 consisting of different types of settlement areas to determine the urban heat island effect on the subsurface of Kütahya. As a result of the measurements, urban heat island maps were prepared. It was observed that the groundwater temperature anomalies increased towards the urban/industrial areas. The difference of groundwater temperature in urban/ rural areas reached up to 7 °C by well. This heat energy increasing with the effect of urban heat island can be used in the heating processes of buildings by utilizing systems called “shallow geothermal energy”. For this reason, the heat potential of the alluvial aquifer under Kütahya was calculated. The theoretical heat potential values of the this aquifer range between 1.64 × 1013 kJ K-1 and 5.55 × 1013 kJ K-1 with a mean value of 3.50 × 1013 kJ K-1.It is thought that urban heat island maps and the heat potential calculations of the aquifers may be important parameters for applicability of shallow geothermal systems in the city center of Kütahya.
https://doi.org/10.19111/bulletinofmre.820395
Systematic and biostratigraphic evaluation of the Late Cretaceous benthic foraminiferal assemblages of southeastern Batman
Authors:
Derya SİNANOĞLU
ABSTRACT
The study area is located in 15 km west of Gercüş town (southeast of Batman) at the northern margin of the Arabian Plate. This region is the only place where Garzan formation, one of the important petroleum reservoir of the Southeastern Anatolia, outcrops and detailed scientific studies have been carried out. The unit, mainly of beige-yellowish, thin-thick bedded, benthic foraminifera and algae bearing limestones, has a rich fossil content and high diversity. This diversity in the benthic foraminifera is noteworthy. These assemblages contains Vandenbroekia munieri Marie, Coskinolina sp., Cyclogyra sp. with porcellaneous test; Biconcava bentori Hamaoui, Nezzazata simplex Omara, Nezzazatinella picardi (Henson), Trochospira avnimelechi Hamaoui, Antalyna korayi Farinacci and Köylüoğlu, Moncharmontia apenninica (De Castro), Moncharmontia compressa (De Castro), Fleuryana adriatica (De Castro), Pseudocyclammina sphaeroidea Gendrot, Broeckinella arabica Henson, Cuneolina pavonia d’Orbigny, Cuneolina ketini Inan, Dicyclina schlumbergeri Munier- Chalmas, Pseudolituonella reicheli Marie, Dictyoconella complanata Henson, Minouxia lobata Gendrot, Minouxia gümbelitrioides Marie, Arenobulimina sp. with microgranular and agglutinated tests and Fissoelphidium operculiferum Smout, Orbitoides medius (d’Archiac), Orbitoides megaloformis Papp and Küpper, Omphalocyclus anatoliensis Özcan, Sırtina orbitoidiformis Brönnimann and Wirtz, Goupillaudina sp. with hyaline test. In this study, the age of Garzan formation has been determined as Maastrichtian based on benthic foraminifera.
https://doi.org/10.19111/bulletinofmre.8099144