Mineral chemistry, Geothermobarometer, Jurassic magmatism, Eastern Pontides, Gümüşhane, Turkey.
Abstract:
In this study, the petrography, mineral chemistry and crystallization conditions were reported for the Alemdar and Işıkdere plutons located in limited areas in the south of the Eastern Pontides. These plutons, which trend mostly in NE-SW directions, were emplaced by cutting the Early- Middle Carboniferous-aged Gümüşhane Granitoid and Early-Middle Jurassic Şenköy formation. Petrographically, the studied plutons are compositionally fine to medium grained quartz-diorite, quartz monzodiorite and tonalite. The rocks in the plutons have granular, poikilitic, monzonitic, graphic and rare porphyritic textures with consist of plagioclase, (An05-92), hornblende (Mg# = 0.52- 0.81), biotite (Mg# = 0.32-0.67), orthoclase, quartz and Fe-Ti oxide. According to thermobarometric calculations, plutons have crystallization temperatures, pressures and oxygen fugacity values ranging from 541°C to 938°C, 0.1 to 4.4 kbar, and -23 to-12, respectively. The estimated water content calculated from amphibole is between 4.4 to 7.8%. It can be concluded that the studied plutons were emplaced at mid to shallow crustal depths (~4-15 km).
Geochemistry of beach sands from the Bartın and Samsun-Ordu coastal districts, Northern Black Sea, Türkiye: implications for provenance
Authors:
Pelin COŞANAY, Halim MUTLU
ABSTRACT
This study aims to investigate geochemical and petrological characteristics, chemical weathering indices and provenance of the beach sands collected from 11 different sites along the coastlines of Bartın, Samsun and Ordu districts adjacent to mafic and intermediate volcanic rocks on the Pontides. Petrological findings show that the abundance of detrital quartz, feldspar and sedimentary lithic fragments increase in beach sands of the Bartın region where the SiO2 values fall in a wide range (47 to 87 wt.%). The Samsun and Ordu beach sands have moderately low SiO2 (50 to 61 wt. % and 48 to 62 wt. %, respectively) and relatively high Fe2O3 contents. LREE concentrations of investigated beach sands show enrichment patterns. Mafic minerals, especially pyroxene and magnetite grains are represented by eroded or abraded morphologies due to dissolution and erosion processes, while opaque heavy minerals show signs of recycling from basic adjacent rocks with etched to subrounded grain surface textures. The low chemical index of alteration (CIA) estimated for the beach sand samples implies the presence of fresh rock erosion along the coasts. We used magnetite to gain better understanding of the formation and origin of Fe-rich beach sands. The mineral chemistry data indicate that studied magnetites have quite similar composition and the mobility of trace elements exerts a great control on their distribution in magnetite.
Keywords:
Beach sand, Black Sea, Heavy Mineral, Mineral Chemistry, Provenance.
Zikrullah Samet GÜLOĞLU, Abdullah KAYGUSUZ, Emre AYDINÇAKIR, Cem YÜCEL
Indexed In · Volume 175 / December 2024
Mineral chemistry, petrography and crystallization conditions of the Middle Eocene Kazıkbeli Pluton (Eastern Pontides, NE Türkiye)
Authors:
Zikrullah Samet GÜLOĞLU, Abdullah KAYGUSUZ, Emre AYDINÇAKIR, Cem YÜCEL
ABSTRACT
The Eastern Pontides host a diverse suite of plutonic rocks spanning a wide range of ages and compositions. Among these, the Middle Eocene Kazıkbeli pluton, located in the Kürtün district of Gümüşhane, stands out due to its distinctive petrological characteristics. This study aims to unravel the petrological implications of petrographic and mineral chemical data to determine the physicochemical conditions (temperature, pressure, oxygen fugacity) under which the Kazıkbeli magma crystallized and was emplaced. By integrating mineral chemical data, we seek to quantify emplacement pressure, crystallization temperature, and oxygen fugacity. A comprehensive understanding of the genetic relationships and physicochemical properties of the Kazıkbeli pluton rocks, as determined through geological, petrographic and mineral chemistry, is crucial for elucidating the geological evolution of the Eastern Pontides. The Kazıkbeli Pluton exhibits a predominant NE-SW orientation and encompasses an area of roughly 46 km². Modal mineralogical analysis reveals a compositional spectrum ranging from gabbroic diorite to monzogranite, with granodiorite and tonalite being the most prominent rock types. Textural variations encompass fineto medium-grained, porphyritic, poikilitic, and occasionally graphic textures. The primary mineral assemblage of the pluton comprises plagioclase, orthoclase, quartz, amphibole, biotite, and Fe-Ti oxides. Accessory minerals include zircon, apatite, sphene, and allanite. Plagioclases are labradorite to oligoclase (An26 to An66) in composition. K-feldspar minerals exhibited an orthoclase composition (Or80 to Or97). All amphiboles belong to the calcic amphibole field and exhibit a magnesio-hornblende (Mg#=0.63-0.73) composition. Biotites crystallized as solidified melt products with compositions between annite and phlogopite endmembers, plotting close to the magnesium-rich (Mg#=0.52- 0.58) end of the phlogopite solid solution series. Calculated crystallization temperatures derived from amphibole and biotite data range from 712°C to 824°C. Pressure estimations calculated using amphibole-plagioclase, amphibole and biotite suggest a range of 0.04 to 2.06 kbar. Oxygen fugacity (ƒO2) values calculated using amphibole and biotite fall between -12.5 and -16.1. Amphibole-based water content estimations indicate a range of 3.7% to 5.7% for the pluton. Biotite compositions within the studied Kazıkbeli pluton rocks exhibit characteristics suggestive of a potential mantle origin. Geobarometric calculations based on mineral chemistry data with geological and petrographic features indicate the emplacement of the Kazıkbeli Pluton at relatively shallow depths within the crust (~1 to 8 km).
Keywords:
Petrography, Mineral Chemistry, Geothermobarometer, Kürtün (NE Türkiye), Eastern Pontides.
The importance of Confocal Raman Spectroscopy and mineral chemistry studies in the magma crystallization processes: Strandja Intrusives, NW Türkiye
Authors:
Ezgi ULUSOY, Yusuf Kağan KADIOĞLU
ABSTRACT
The Strandja Massif cropping out in NW Turkey is cut by Late Cretaceous intrusives. These are called Strandja Intrusives and they are felsic and mafic coeval intrusives. Felsic intrusives consist of granite, granodiorite, quartz monzonite and syenite, while mafic intrusives consist of diorite and gabbro composition. Main composition of felsic intrusives consists of quartz, alkali feldspar, plagioclase, biotite, amphibole ±pyroxene mineral association, while main composition of mafic ones consists of plagioclase, biotite, amphibole ±pyroxene ±olivine mineral association. Amphiboles hydrated double-chain mineral of the Strandja Intrusives observed in all rocks used as an index mineral in this study to understand the petrological evolution of the rocks. According to Confocal Raman Spectroscopy studies amphiboles were actinolite type and exhibited similar spectrum and results of mineral chemistry reveals that they were calcic/Mg-hornblende types. According to geothermobarometer calculations, amphiboles crystallize in felsic intrusives at a pressure range of 0.49-0.94 kbar and a temperature of 757.52-814.49oC temperature at a depth of approximately 1.34-4.93 km, while in mafic ones at 2.59 kbar pressure and 892.82oC temperature at 9.97 km depth. Different temperatures-depth conditions and overlaps in Raman shift obtained from amphiboles indicate that these intrusives are derived from different sources but crystallized in the same environment.
Keywords:
Amphibole, Strandja Intrusives, Confocal Raman Spectroscopy, Mineral Chemistry, Geothermobarometry
Morphological parameters causing landslides: A case study of elevation
Authors:
Seda ÇELLEK
ABSTRACT
The history of landslide susceptibility maps goes back about 50 years. Hazard and risk maps later followed these maps. Inventory maps provide the source of all these. There are different parameters selected specially for each field in the literature as well as parameters selected because they are easy to produce and obtain data. This study tried to research the effect of elevation on landslides by reviewing the literature in detail. The used class ranges and elevation values were reviewed and applied to map sections selected from Turkey. By analyzing the results, the goal was to determine at which elevation ranges landslides occurred. The study tried to investigate the effect of the parameter of elevation using data from the literature. It works to compare the elevation values for map sections selected to compare with the literature. The study comprises two stages. The first step tried to acquire statistical data by researching the data from the literature. The data were investigated in the second stage. For this purpose, close to 1.500 studies prepared between 1967 and 2019 were reviewed. According to the literature, the parameter of was used in analyses because it is easy to produce and is morphologically effective.
https://doi.org/10.19111/bulletinofmre.649758
Mohammed Tayeb ABEDGHARS, Mokhtar GHERS, Salah BOUHOUCHE, Belgacem BEZZINA
Indexed In · Volume 162 / 2020
Characterization of iron ore and scale for synthesizing vinyl paint
Authors:
Mohammed Tayeb ABEDGHARS, Mokhtar GHERS, Salah BOUHOUCHE, Belgacem BEZZINA
ABSTRACT
Two materials are studied to synthesize a vinyl painting. Iron ore is an iron pigment with an oolithic structure containing phosphorus. The second material is a steel by-product. The raw materials proprieties were studied by chemical, particle size, thermal, XRD and spectrophotometric analysis. The iron contents of the pigment and scale are respectively 53.18% and 73.83%. The grindability of scale is better than that of the pigment. The particle volume distribution is 0.7 to 32 µm for scale and 0.6 to 40 µm for pigment. TGA and DTA tests show that the pigment loses weight with phase dissolution by consuming energy and the scale gains weight with the formation of a new phase when the temperature increases. The SEM of the scale showed a homogeneous structure of iron oxide grains ranging from 1 to 10 μm. XRD analysis shows that the iron in the pigment is in the form of (Fe2O3) and FeO (OH)) and very little (Fe2SiO4). The iron in the scale is in the form of (FeO, Fe2O3 and Fe3O4). Spectrophotometric tests show that the two materials have no absorption and their reflection is maximum (100%) in the visible range.
https://doi.org/10.19111/bulletinofmre.604081
Kamil KAYABALI, Ramin ASADİ, Mustafa FENER, Orhan DİKMEN, Farhad HABİBZADEH, Özgür AKTÜRK
Indexed In · Volume 162 / 2020
Estimation of the compaction characteristics of soils using the static compaction method
Authors:
Kamil KAYABALI, Ramin ASADİ, Mustafa FENER, Orhan DİKMEN, Farhad HABİBZADEH, Özgür AKTÜRK
ABSTRACT
Ground improvement using mechanical stabilization is commonly applied by performing the standard Proctor compaction test, which requires a significant quantity of soil, usually obtained from open pits. A static compaction test is an alternative laboratory compaction test. Although researchers have shown that the results of miniature size static compaction tests are comparable with that of standard Proctor tests in terms of the maximum dry density and the optimum water content, no attempt has been made to compare the two fundamental properties of the compacted soil: undrained shear strength and hydraulic conductivity. The scope of this investigation was to estimate the level of static compaction energy required to (1) obtain a compaction curve similar to that of the standard Proctor test; (2) reconstruct compacted soils using the standard Proctor and static compaction tests at the optimum water content; and (3) compare the undrained shear strength and hydraulic conductivity of compacted soils. The compacted soils at the predetermined energy level were subjected to hydraulic conductivity tests using the rigid-wall falling-head permeability method. Undrained shear strength tests were performed by employing a high-capacity laboratory vane shear apparatus on compacted samples of both the standard Proctor and static compaction tests. The present investigation revealed that the static compaction test, requiring about only 10% of the soil necessary to perform the standard Proctor method, provides comparable results in regard to hydraulic conductivity and undrained shear strength.
https://doi.org/10.19111/bulletinofmre.603873
Keywords:
Static compaction, Standard Proctor, Unconfined compressive strength, Permeability, Compaction energy.