Separation of geochemical anomalies from background plays an important role in the study of exploration geochemistry. The limitations of commonly used methods are not taken into account spatial correlation, variability and the unsatisfactory of the statistical assumption of the normality of geochemical data. For solving these limitations, an indirect method for the separation of geochemical anomalies is proposed based on anomaly separation of local Moran’s Ii values using robust statistics in this study. The experiment was carried out using 1481 samples collected from Jiurui copper prospect (southeast China). The steps for the anomaly separation are (i) spatial association and variability were fi rst analyzied by means of Moran scatterplots at six spatial scales (2, 4, 6, 8, 10 and 12 km) using both raw data and Box-Cox transformed data; (ii) local Moran’s Ii was used to measure spatial autocorrelationat these six local scales; (iii) anomalous separation was fi nally performed using the MEDIAN ± 1.5*IQR (IQR: interquartile range) rule on local Moran’s Ii values. The results show that geochemical anomalies are mostly concentrated around known ore-deposits, according the objective reality and a strong correlation with known ore-deposits in Jiurui copper prospect.
Separation of geochemical anomalies using inverse distant weighting (IDW) and concentration-area (C-A) fractal modeling based on stream sediments data in Janja Region, SE Iran
Authors:
Marzieh Hosseininasab, Ali Akbar DAYA
ABSTRACT
In this study, the Inverse Distant Weighting (IDW) and the Concentration –area (C-A) fractal methods were used for identifi cations of geochemical anomalies in Janja region, SE Iran. Eight elements (Au, Cu, Mn, Zn, Fe, As, Mo, and Pb) from 300 stream sediment samples were used. The studied area was gridded by 250 m×250 m cells. Estimation of unsampled locations were carried out by inverse distant squared weighting (IDWS) method. Geochemical maps were generated. Log- log plots of cumulative frequency of elemental concentrations versus related areas were constructed. Threshold values were obtained by fi nding break points in the log-log plots. There were four geochemical populations for As, Fe, Mo, Pb and Zn and fi ve geochemical populations for Au, Cu, and Mn. The resulted geochemical anomaly maps obtained from fractal modelling showed that Anomalies of Zn, Mo, Mn, Fe, Cu and As located in southeastern part of study area. There was a good correlation between faults and elementals anomalies. It can be concluded that mineralization occurred along the faults. There was a correlation between anomalies and sedimentary rocks (alluvium and recent alluvium sediments) in SE part of study area. Gold anomalies were located in the NW parts of the studied area. There was a strong relationship between the location of Au anomalies and fault systems in the NW parts of the studied area. Iron concentrations were sporadic and correspond to the sedimentary volcanic rock and turbidites.
http://dx.doi.org/ 10.19076/mta.401236
Characterization and dewatering of borax clayey tailings by mono- and dual-flocculants systems
Authors:
NURAY KARAPINAR
ABSTRACT
This study includes dewatering of Kırka Borax Concentrator tailings by fl occulation with mono- and dual-fl occulants systems. Four polyacrylamide (PAM)-typed anionic and a poly diallyl-dimethylammonium chloride (PolyDADMAC)-typed cationic polymers were used as fl occulants in monoand dual-fl occulants systems to fl occulate tailings. Tailings slurry sample used in the experiments were taken from the discharge point of Kırka Borax Concentrator. Prior to the fl occulation tests, physical, chemical and mineralogical analysis were carried out to characterize the tailings slurry. Results reveal that while tailings solid consists mainly of dolomite and montmorillonite with some unrecoverable boron mineral fi nes and very minor amount of calcite and quartz, tailings water is typical with the content of quite high dissolved carbonate and borax with a pH of 9.4. Flocculation tests were performed in one liter graduated cylinder at inherent pH of the tailings slurry sample. Settling rate and turbidity of overfl ow was measured as important factors for evaluating the fl occulation performance of different fl occulants. The tailings slurry as received showed a very low settling behavior due to the clay content and high percentage of fi ne particles. Flocculation of tailings with anionic fl occulants accelerated the settling rate of particles without providing a clear supernatant. But, dual-fl occulants system, in which anionic and cationic type polymeric fl occulants were used, was able to provide a clear supernatant at relatively higher settling rates.
http://dx.doi.org/10.19111/bulletinofmre.336392
Palynology of the Kılçak formation (Early Miocene) from Central Anatolia: Implications for palaeoclimate and palaeoenvironment
Authors:
Nurdan YAVUZ, Şükrü Sinan DEMİRER
ABSTRACT
The palynological analysis of the early Miocene successions of the Kılçak formation (Central Anatoia, Turkey) was carried out in order to reconstruct the palaeovegetation. The pollen spectra indicate a fl ora dominated by Pinus, co-dominance of Cupressaceae in one of the investigated successions, and lower percentages of trees such as Taxodioideae within Cupressaceae, Quercus deciduous type, Carya, Carpinus, Ulmus, Engelhardioideae, Salix, Alnus and Juglans. Herbs are represented by minor amounts of Poaceae, Amaranthaceae/Chenopodiaceae and Asteraceae. This flora indicates the presence of a Taxodium topogenous mire with a nearby riparian vegetation and broadleaved deciduous mixed forests developed in the surrounding distant mountainous areas. δ13C analysis shows that the vegetation was dominated by C3 plants. The Kılçak palynoflora reflects a humid, warm-temperate climate being compatible with the global warm conditions maintained during the early Miocene
http://dx.doi.org/10.19111/bulletinofmre.395784
Keywords:
Palynology, palaeoclimate, early Miocene, Kılçak formation, Central Anatolia.