Uncertainty-volume fractal model for delineating copper mineralization controllers using geostatistical simulation in Nohkouhi volcanogenic massive sulfide deposit, Central Iran
The aim of this study was to delineate copper mineralization controllers in Nohkouhi volcanogenic massive sulfide (VMS) deposit by using geostatistical and fractal simulation. In this study, concentration-volume (C-V) fractal model has been used to indicate various copper populations related to different host rocks and copper minerals. Accordingly, uncertainty-volume (U-V) fractal model was applied to probability values achieved through sequential indicator simulation (SIS). Copper ores of Nohkouhi deposit including chalcopyrite and malachite were simulated in 30 realizations. The U-V fractal model obtained by using a probability map was divided into four probability zones (high, moderate, low, and very low) for copper minerals. Furthermore, copper grades were simulated for 10 times by sequential Gaussian simulation (SGS). Combination of C–V and U-V fractal modeling resulted in a hybrid method which could be properly employed to determinate various mineralization zones based on the relationship between quantitative (e.g.copper grade) and qualitative (e.g. copper minerals) variables. Moreover, integrating the results of C–V and U-V fractal modeling with the most frequent occurrence of rock type modeling helps identify copper mineralization controllers in a VMS deposit.
https://doi.org/10.19111/bulletinofmre.495753
INVESTIGATIONS OF ALTERATION ZONES BASED ON FLUID INCLUSION MICROTHERMOMETRY AT SUNGUN PORPHYRY COPPER DEPOSIT, NW IRAN
Authors:
Omid ASGHARI, Ardeshir HEZARKHANI
ABSTRACT
The Sungun porphyry copper deposit is located in East Azerbaijan, NW of Iran. The porphyries occur as stocks and dikes ranging in composition from quartz monzodiorite to quartz monzonite. Four types of hypogene alteration are developed; potassic, phyllic, propylitic and argillic. Three types of fluid inclusions are typically observed at Sungun; (1) vapor-rich, (2) liquid-rich and (3) multi-phase. Halite is the principal solid phase in the latter. The primary multiphase inclusions within the quartz crystals were chosen for micro-thermometric analyses and considered to calculate the geological pressure and hydrothermal fluid density. In potassic zone, the average of homogenization temperature is 413.6°C while in phyllic alteration, 375.9 °C. As expected in potassic alteration, the temperature of hydrothermal solutions is higher than that in phyllic zone. The salinity of the hydrothermal fluids has a high coherency with homogenization temperature, so the average of salinity in potassic samples is 46.3 (wt% NaCl) which is higher than phyllic samples. Based on the location of potassic alteration, as expected, the lithostatic pressure is much more than the phyllic one. Finally, the average density of hydrothermal fluids in the potassically altered samples is 1.124 (gr/cm3 ) which is higher than the ones in phyllic zone (1.083 gr/cm3 ).