BULLETIN OF THE MINERAL RESEARCH AND EXPLORATION (MTA Dergisi)
AUTHOR PROFILE
Articles by Mustafa ALBAYRAK
3 PUBLICATIONS
01
Volume 176 / 2025 · Pages: 57-75
Mehmet ÇÖTELİ, Mustafa ALBAYRAK, Ufuk KİBAR, Arzu YAVUZ, Gülsüm TURGUT, Duran Serdar KARAHAN
Indexed In · Volume 176 / 2025
Mineralogical examination of biomass ashes: A preliminary study for potassium enrichment and phosphoric acid (H3PO4) production
Authors:
Mehmet ÇÖTELİ, Mustafa ALBAYRAK, Ufuk KİBAR, Arzu YAVUZ, Gülsüm TURGUT, Duran Serdar KARAHAN
ABSTRACT
In this study, biomass fly ash was investigated and determined by XRD (XRay Diffractometer) to be predominantly langbeinite, aphthitalite, sylvine, apatite and hydroxyapatite. An alkaline leaching study was carried out on the material in a glass reactor at l/s ratio 4 temperature 60°C at pH 12.85 and after drying was analyzed by ICP (Inducted couple plasma). The crystal structure composition of K2SO4 72.28% and potassium content of 33.47% (w/w) was recovered. The elemental transformations in this leaching process were: K 74.16%, Mg 0.55% was found to be 0.8%. It was found that a minimum of 4.84 g H2SO4 per 100 g fly ash was required to precipitate the Ca(OH)2 migrated into the liquid solution and the overall leaching efficiency was found to be 29.85%. In the alkaline leaching process, potassium was found to be easily recovered from each biomass ash. By adding 40 g H2SO4/100 g biomass waste remaining after leaching, a phosphorus recovery of 74.9% was observed. In this preliminary study, unsatisfactory results were obtained in obtaining the industry standard H3PO4. The reason for this is that the Al, Mg and K in the fly ash are subject to selective dissolution as a result of working at high pH in the alkaline leaching process.
MINERALOGICAL AND TECHNOLOGICAL PROPERTIES OF THE ZEOLITES FROM FOÇA (İZMİR), BİGADİÇ (BALIKESİR) AND GÖRDES (MANİSA)
Authors:
Günnur ULUSOY, Mustafa ALBAYRAK
ABSTRACT
Technological analyses of zeolites are important for their areas of use. Zeolite samples were collected from different regions (İzmir-Foça, Balıkesir-Bigadiç, Manisa-Gördes) for this study. First mineralogical and chemical analyses of the samples were conducted in the study. Later on, technological tests of the samples were made for their utilizing in ceramic industry (pre-technological), in paper industry (filling and coating) and as cat litter. Finally, the results were evaluated. It was concluded that some samples can be used in baked ceramics in the ceramic industry; they have high whitening properties to be used in paper industry. As for cement additives, their flexural strength is observed in a range between 0,94 - 12,85 kgf/cm2 while their compressive strength is between 2,08 - 51,20 kgf/cm2. The porosity of some samples is above 40% which means they meet the criteria to be used as soil conditioners.