The relationship between seismic quality factor and peak ground acceleration, a case study: M=4.3, 17.01.2015 Eskişehir Earthquake
Authors:
Muammer TÜN
ABSTRACT
Seismic wave propagation in subsurface media endures from absorption, which can be evaluated by the seismic quality factor Q (Q-factor). Absorption is frequency-dependent. Lower frequencies are absorbed less, while higher frequencies are absorbed more. Therefore, the Q Factor should be determined in the frequency domain. Q-factor is determined by the slope of the natural logarithm of the output-input signals ratio. Surface waves (Rayleigh and Love waves) are particularly important, as they are the more destructive phases of an earthquake. This study was, focused on the Q-factor computation of the surface waves and demonstrated that the determination of the Q-factor is not affected from the dispersive properties of the surface waves. Data were obtained from surface wave signals of earthquake recorded at Eskişehir Technical University Seismic Network - EstuNet. The obtained Q-factor values represent the average values of the rocks that the waves cross between the input and output stations. Finally, the Q-factor map to the Peak Ground Acceleration (PGA) map using the M=4.3, 17.01.2015 Eskişehir earthquake data was compared. These records show the arrival time of the earthquake from the epicenter to the stations of the seismic waves, and the peak ground acceleration values. In this study, local site effects of EstuNet accelerometric stations have been calculated by using the Standard Spectral Ratio (SSR) method. It is concluded that an inverse relationship exists between the computed Q-factor and measured PGA values. Therefore, the sites where the Q factor is very low should be analyzed in more detail in ground-based earthquake risk assessments.
https://doi.org/10.19111/bulletinofmre.841785
Using of GIS on field geology studies: An application on central-southern of Eskişehir
Authors:
Coşkun GÜNEŞ, Emrah PEKKAN, Muammer TÜN
ABSTRACT
Technological developments on Geographical Information Systems (GIS) make possible to use its applications on all departments of earth sciences. GIS based drill-hole data, lithological and structural maps are used integrated with field geolgy investigations in this study. The area where is bordered Batıkent-Yukarı Söğütönü districts on northwest and Vadişehir-Ihlamurkent districts on southeast is defined as study area. 44 water wells drilled by State Hydraulic Works (DSİ) are located in various points of Eskişehir region were transformed to GIS base. Geological cross-sections which were designed by drill-hole lithology are point out a disconformity zones between Paleogene and Neogene according to principle of lateral continuity. Neotechtonic researches on study area Show thah right lateral strike slip shear zone dominates the region structurally. Searching these structural traces on the field and representing new field evidances by using GIS on the regions where there is no consensus stratigraphicly are the main purposes of the study. Geological map of the region where lies between Çankaya and Karapınar districts without consensus stratigrapichly was made by field observations on Miocene units. The other surface evidances include dilation fractures, strike-slip faults are support the idea which is suggested for Eskişehir region as right lateral strike-slip shear zone.
https://doi.org//10.19111/bulletinofmre.669305
Keywords:
Eskişehir basin, Geographial information systems, Field geolgy, Stratigraphy.