Usability value of the Yenicekale formation exposure around the Pazarcık (Kahramanmaraş) as a cement raw material
Authors:
Güldemin DARBAŞ, Fatma BAYRAK, Ali GÜREL
ABSTRACT
The study area is located around Pazarcık - Narlı, Kahramanmaraş province. The aim of the study is to investigate the value of units belonging to the Yenicekale Formation Kışla Marl Member as cement raw material. As a result of XRD studies, it was determined that Yenicekale formation Kışla Marn Member which is exposed to large areas in the region is composed of illite, quartz, dolomite, calcite, and chlorite minerals by rock analyzed. By geochemical analysis, SiO2, Al2O3, Fe2O3, CaO, MgO, K2O, Na2O, SO3 contents of the units were determined and these values were compared with the limit values used in cement raw materials. When the results were evaluated, it was determined that the total alkali elements (Na2O+ K2O) were within the limit values, but others were below or above these limit values. In addition, with geochemical analyses, it was calculated Silicate and Aluminium Modules. The most suitable values for Silicate Modules in Turkish Cement Factories are 2.2 - 2.6. In this study, Silicate Modulus values are in the range of 1.94 - 5.22. Standard values or Aluminum are between 1.5 and 2.5. The values of Aluminum Modules determined in this study are in the range of 0.43 - 1.38. For Hydraulic Module, the standard values are in the range of 1.8 - 2.2. The values determined in this study are in the range of 0.24 - 5.
https://doi.org/10.19111/bulletinofmre.856536
Physicochemical properties and availability of Tahar-Güzelöz (Nevşehir) diatomite
Authors:
Ayşegül YILDIZ, Ali GÜREL, Dilan OKUTAN
ABSTRACT
In this study, the use areas of diatomites located within the late Miocene-Pliocene volcano sedimentary units, which formed due to the volcanism and outcropped around the Tahar and Güzelöz localities, Nevşehir, were investigated in terms of raw materials. To do this, three stratigraphic sections were measured in the study area, one of which was measured in the Tahar area (TK), and two others were measured in the Güzelöz area (GÜ1 and GÜ2). Various physicomechanical, chemical, mineralogical and analytical methods were applied on the collected samples. The analysis results of diatomites in the investigated area were determined as follows; the amount of acid-insoluble matters; 74,20 - 84,20%, the amount of water-insoluble matters; 99,80 %, the loss on ignition ratios (950 °C de); 8,18 - 22,82 %, whiteness; 80,45 - 84,79%, the particle sizes; 0,7-209 µ , pore sizes; 1,448 e-03A – 5,888 e-04A, pore volumes; 1,148 e-02 – 8,515 e-02 cc/g, specific gravities; 2,33 – 2,49 g/cm3 , total porosities; 57 –60%, cumulative specific surface areas; 4,047 e+01 – 5,160 e+01 m2/g, pH; 5-7 (acid and neutral), filtration rates; 138 – 351 ml/min and SiO2 contents; 38,16 – 67,77%. It was determined that samples did not contain any palynological material and these generally were formed from long and coarse diatom genus and species. The evaluation of analysis results showed that diatomites of none of three locations were suitable as construction material, carrier, abrasive, cleaner and insulating material. At the same time, it was also determined that diatomites of the Tahar and Güzelöz–1 locations could not be used as the filling material. In addition, it was also detected that these diatomites could be used in the manufacture of silicate and as percolator by the SiO2 enrichment. Also, the diatomites of Güzelöz-2 can be used as the filling material in rubber and paper industries.
DOI: 10.19111/bulletinofmre.428305
Keywords:
Diatomite, Industrial Raw Materials, late Miocene-Pliocene, Güzelöz, Kızılkaya Ignimbrite, Nevşehir, Tahar, Tahar Ignimbrite,
PHYSICOCHEMICAL PROPERTIES AND USES OF KARACAÖREN AREA (NEVŞEHİR) DIATOMITE
Authors:
Ayşegül YILDIZ, Ali GÜREL, Yusuf Gökhan DURSUN
ABSTRACT
In this study, physicochemical properties and uses of diatomites which are formed due to Central Anatolia volcanism and outcropping in Karacaören (Ürgüp country, Nevşehir) area were investigated. Two stratigraphic sections were measured in the investigated area, one of these sections was measured in the Quaternary lake units (K1), and the other section was measured in the lacustrine sediments of late Miocene-Pliocene Ürgüp Formation’s Bayramhacılı Member (K2). The specify to physicochemical properties and uses of study area’s diatomite, loss on ignition (1050 ° C), XRD, amount of acid and water-insoluble matter, thermal conductivity (in the range of 101; 150 ° C and ± 10 ° C), XRF, pH, total porosity, specific gravity, specific surface area, pore volume, pore size, whiteness, particle size and SEM analysis were carried out at the General Directorate of Mineral Research and Exploration Laboratories on the samples collected from the area. The evaluation of the analyses results showed that, the subject diatomites have commercial value and it can be used directly in percolator, as a filler and structuring agents and in the manufacture of silicate. In addition, it can be used as mild abrasive and cleaner, in the manifacture of isolution material after processing
Keywords:
Uses Of Diatomite, Physicochemical Properties, Late Miocene-Pliocene, Karacaören, Quaternary