Kızıllar Canyon, Central Taurides, Central Anatolia, Fault, Uplift Rate
Abstract:
The study area is located near the apex of the north-facing and V-shaped Konya-Niğde Graben. Its south-southeast margin is defined and controlled by the NE-trending Karaman-Niğde Fault Zone. It also forms the geographic boundary between the central Tauride in the south and central Anatolia in the north. This study aimed to determine the Latest Pliocene-Quaternary uplift rate of the central Tauride and the evolutionary history of the Kızıllar Canyon located on the uplifting southern footwall block of the Karaman Niğde Fault Zone. Both the geological and geomorphological field data, which were obtained within the framework of this study, revealed the following: (1) the Kızıllar River drainage system developed as a result of several capture events; (2) Lithological and hydrological characteristics of the valley reveal the reason for the lack of gradation in the river’s longitudinal profile; (3) the Kızıllar Canyon reflects the incision process of the Kızıllar River; (4) the Kızıllar River cut vertically into its bed up to 230 m, which corresponds to the minimum Latest Pliocene- Quaternary uplift rate of the central Tauride (~0.06 mm/yr); and (5) the Kızıllar Canyon developed as a natural response of the river to the uplift of the Konya-Niğde Fault Zone footwall block.
The Dodurga Fault is an active right-lateral strike-slip fault, approximately 63 km long, striking NW-SE in northwestern Anatolia. Based on 1:25,000-scale active fault mapping, the fault is subdivided into two principal geometric segments. Segment 1 is approximately 16 km long and extends from Sulhiye in the west to Erikli in the east, whereas Segment 2 is 47 km long and is characterized by a right-stepping geometry and a 10°-15° southeastern deflection. Geological and geomorphological observations, together with kinematic analyses, indicate that the fault is dominantly right-lateral strike-slip in character. Stream channels offset by up to several kilometers along the fault trace support its long-term activity, and fault-plane kinematic indicators independently confirm dextral motion. Paleostress analyses of the kinematic data indicate that the recent deformation phase along the Dodurga Fault is governed by approximately N-S contraction and E-W extension. Empirical scaling relationships suggest that Segment 1 and Segment 2 are capable of generating earthquakes of Mw 6.47 and Mw 6.97, respectively. If both segmentsrupture together, the Dodurga Fault could potentially generate an earthquake of Mw 7.16.
Evaluation of the tectonic activity of faults with mineral alterations: a case of the East Anatolian Fault-Palu segment, Türkiye
Authors:
Firdevs GÜZEL, Gülcan SARP
ABSTRACT
Palu segment is a part of the East Anatolian Fault Zone (EAFZ), the most important active leftlateral strike-slip fault system in Turkey, and there are different mineral alterations in this zone. The study tested the spatial relationship between tectonic activity and mineral alterations with the Getis-Ord Gi* statistic in and around the Palu segment. Mineral alterations at the pixel level were determined from ASTER images by Ratio, Relative Band Depth (RBD), Mineral Indices, CROSTA, Constrained Energy Minimization (CEM), Mixed Tuned Matched Filter (MTMF) methods. According to the results, the spatial distribution of alteration minerals extending parallel to tectonically active fault lines and/or partially bounded by faults in the area. RBD, Mineral Indices, CROSTA, CEM, and MTMF image processing algorithms applied in the study gave consistent results in the spatial determination and mapping of mineral alterations in the study area. At 99% and 95% confidence intervals, statistically significant cold spot clusters indicate the proximity of alterations to faults concentrated around fault lines. This degree of clustering of mineral alterations indicates regions with high alteration rates close to fault lines and areas with tectonic activity along fault lines.
Keywords:
Active Tectonics, Alteration Minerals, Getis-Ord Gi* Statistic, ASTER.
Structural Geology, Active tectonics · Volume 172 / December 2023 · Pages: 119-140
Ali KOÇYİĞİT
Indexed In · Volume 172 / December 2023
Neotectonics of the Sarıköy-İnova and Çan-Bayramiç-Ezine fault zones: basin formation, age and slip rates, NW Anatolia-Türkiye
Authors:
Ali KOÇYİĞİT
ABSTRACT
The Sarıköy-İnova and the Çan-Bayramiç-Ezine fault zones (SIFZ, ÇBEFZ) comprise the southern strand of the North Anatolian Fault System in the Biga Peninsula. They are located in the area between Sarıköy to northeast and the Dalyan settlement around Bozcaada in the North Aegean Sea to southwest. Both of the fault zones are active. This is evidenced by the 6 March 1737 (Ms =7.0) İnova, 1st February 1809 Hurma (Ms = 6.1), and the 8 February 1826 Güllüce (Ms = 6.2) historical earthquakes resulted from these fault zones. Maximum lengths of fault segments comprising the SIFZ and the ÇBEFZ are 14 km and 15 km, respectively. Based on the maximum lengths of fault segments, the magnitude of the peak earthquakes to be originated from these faults are Mw = 6.3 and 6.6, respectively. Based on both the geological and geographic markers, the total right lateral offsets accumulated on the SIFZ and ÇBEFZ are 12 km and 20 km, respectively. These offset values imply to the slip rates of 4.6 mm/yr and 7.7 mm/yr, respectively. Five pull-apart basins were developed on both fault zones. These are the Sarıköy, İnova, Kazabat, Çan and Ezine-Bayramiç basins. The first three of them are pure strike-slip pull-apart basins, while the type of the rest basins is superimposed. The angular unconformity between the nondeformed basin fill of Quaternary age and the folded to thrust-faulted basement rocks of pre-Quaternary age reveals strongly that the pull-apart basins have formed during the Quaternary time. This relationship also reveals that the commencement age of the strike-slip neotectonic regime and formation of associated fault zones are the Early Quaternary. This work was dedicated to the retirement memory of Dr. Fuat Şaroğlu.
A thorough comparison of newly discovered whetstone from the Dazkırı (Afyonkarahisar – Türkiye) with a heritage whetstone from the Cretan Island-Greece with regards to mineralogical, petrographic and physico-mechanical characteristics
Authors:
Osman Serkan ANGI, Orhan YAVUZ, Emin ÇİFTÇİ
ABSTRACT
The present study is an analytical investigation into the geomaterial and engineering geological characteristics of Cretan (Greece) and Dazkırı (Afyonkarahisar, Türkiye) whetstones. The Cretan whetstone, a prominent example of a heritage natural whetstone, is a distinctive type of carbonatecemented siltstone that is extracted from the island of Crete in Greece. Conversely, a new specimen was recently identified by the authors and designated as “the Dazkırı whetstone,” which exhibits comparable lithology and is extracted in the Dazkırı district of Afyonkarahisar (Türkiye). In order to ascertain the geomaterial characteristics of the studied whetstones, a number of analytical and test techniques were utilized. Furthermore, Cerchar Abrasivity Index (CAI) measurements were conducted and acquired. The CAI results were then compared through the use of regression equations related to quartz content, cementation degree, and the Böhme surface abrasion resistance. The oil absorption test was finally conducted to ascertain the grinding-honing performances and impregnation capacity with lubricant of the examined whetstones. Consequently, a comparative analysis of the subject whetstones was conducted, resulting in the definition and classification of their characteristics. These characteristics included the relationship between grain size and grit size equivalent, as well as the type of lubricant, function, and uses. In summary, the Dazkırı whetstone exhibits superior geomaterial characteristics and grinding-honing performance when compared to the Cretan whetstone.
Keywords:
Whetstone, The Cretan Whetstone, The Dazkırı Whetstone, Geomaterial Characteristics, Grinding- Honing Performances.
Dornadula CHANDRASEKHARAM, Govind UMMETHALA, Tripathi RAJENDRA PRASAD, Amir Hossein TAVABI, Sairam Krishna MALLADI, Rafal E Dunin BORKOWSKI, Dixit AMBESH
Indexed In · Volume 180 / August 2026
High resolution microscopy and Raman spectroscopic studies on the freshest Mukundpura meteorite, Rajasthan, India: Presence of nanodiamonds
Authors:
Dornadula CHANDRASEKHARAM, Govind UMMETHALA, Tripathi RAJENDRA PRASAD, Amir Hossein TAVABI, Sairam Krishna MALLADI, Rafal E Dunin BORKOWSKI, Dixit AMBESH
ABSTRACT
Carbonaceous Chondrites have special significance in the stellar evolution and in particular in the evolution of life on earth. The carbonaceous meteorite that fell in Mukundpura village, Jaipur, Rajasthan on 6th June 2017 is one such rare CM2 (Carbonaceous Chondrite) carbonaceous meteorite. We carried out high resolution scanning and transmission electron microscopic (SEM and TEM) studies on typical thin sections, showing abundant grains of iridium (Ir), pentlandite (NiS), and more interestingly crystalline carbon (C). These crystallite carbon grains resemble nanodiamond like signature in the freshest Mukundpura meteorite. The high-resolution Raman spectroscopic measurements are carried out on the crystalline carbon grains, showing well resolved three distinct peaks with a vibrational mode at 1315 cm-1, with the onset of a weak vibrational mode at 1150 cm-1, substantiating the observation of nanocrystalline diamond in Mukundpura meteorite. The broad peak centered at 1360 cm-1 and 1575 cm-1 (as an average), suggest the presence of graphitic carbon as well together with apparent presence of nanocrystalline diamond. The average size of nanocrystalline diamond is ~ 3-5 nm. High iridium content in this meteorite supports the meteoric impact related iridium anomaly in geological stratigraphic boundaries (e.g. Cretaceous-Tertiary boundary) that has caused mass extinction of flora and fauna.
Keywords:
Meteorite, Mukundpura, Nanodiamond, Raman Spectroscopy, TEM, Iridium Anomaly, Pentlandite, Mass Extinction.
Formation of carbonate-hosted Kızılüzüm Pb–Zn–Ag deposit within the Bornova Flysch Zone, İzmir, Western Türkiye
Authors:
Bezhan BEHZAD, Cem KASAPÇI, Nurullah HANİLÇİ
ABSTRACT
The Kızılüzüm Pb-Zn-Ag deposit is hosted within carbonate rocks belonging to the Bornova Flysch Zone (BFZ) in Western Anatolia. The base of the BFZ in the study area comprises Upper Cretaceous recrystallized dolomitic limestones with rudist fossils, overlain by Late Cretaceous-Paleocene flysch-type sequences consisting predominantly of fossil-free sandstone and shale alternations, along with occasional limestone lenses. Cataclastic granitic dike, possibly of Miocene (?) age, intrudes these units. The BFZ exhibits an imbricated internal structure, and the Kızılüzüm Pb-Zn- Ag mineralization has developed within the recrystallized dolomitic limestones particularly at the intersections of low-angle thrust zones and faults. The ore zone is oxidized and contains 0.4-44% Zn, 0.2-12.5% Pb, 65-3305 ppm As, and 1.5-347 ppm Ag. The moderately strong correlation of Ag with Pb and sulfur (r = 0.7) suggests its association with galena. Fluid inclusions yield an average homogenization temperature of 238 °C (Th) and 5.4 wt.% NaCl equivalent salinity, indicating a dominantly magmatic-hydrothermal origin for the ore-forming fluids. δ34S for sulfide minerals average -6.89‰ (range: -11.95‰ to 4.46‰; n = 27), while barite shows 8.75‰ (range: 0.67‰ to 14.05‰; n = 5). These data suggest that sulfur may have been derived from dominantly magmatic sulfate sources with partly sedimentary sulfate contribution, reduced and fractionated through thermochemical sulfate reduction (TSR) processes. Considering its geological setting, mineral paragenesis, fluid inclusion data, sulfur isotope compositions, and ore geochemistry, the Kızılüzüm Pb-Zn-Ag mineralization may have been formed through the mixing of magmatic-hydrothermal fluids derived from Oligocene-Miocene magmatic rocks intruded into the Bornova Flysch Zone (BFZ) and shows similarities to Carbonate Replacement Deposit (CRD)-type Pb-Zn deposits worldwide.