Lower-Middle Devonian, conodont fauna, biostratigraphy, İstinye Formation, Kozyatağı member, İstanbul
Abstract:
The conodont faunas defi ning the delta-pesavis zones (upper Lochkovian, Lower Devonian) were obtained from Beykoz and Karamandere sections of the İstinye Formation (the Yumrukaya group) and the conodont faunas of the laticostatus, serotinus, patulus and partitus zones (upper Emsian-lower Eifelian, Lower-Middle Devonian) were obtained from the Büyükdere and Kokarpınar sections of the Kozyatağı member of the Kartal Formation. A total of 22 species/subspecies were described belonging to the genera Neopanderodus (2), Icriodus (8), Pelekysgnathus (1), Lanea (1), Polygnathus (4), Ozarkodina (2), Pseudooneotodus (2), Belodella (2).
Bivalvia biostratigraphy of Aksütlü region (Hekimhan, NW Malatya, Türkiye) and paleoclimatological interpretations
Authors:
Müjde GÜRSOY
ABSTRACT
In this study, Early Miocene bivalve fauna obtained from Hekimhan Aksütlü locality is presented. Abundant and well-preserved ostreid samples are interesting in the area where molluscs have not been studied before. Within the community where ostreids are dominant, eight species have been identified; four species of the Ostreoidea, two Pectinoidea, one Arcoidea and one Cardioidea have been recorded. The Carbon (13C/12C) and Oxygen (18O/16O) isotope ratio results of the ostreids and sediments indicate the first findings related to the Miocene Climate Optimum (MCO) Event in Anatolia. Identified bivalves reveal that Akyar Formation was deposited in a shallow and warm sea
in Early Miocene.
Keywords:
Malatya Basin, Early Miocene, Bivalvia, Isotope, Paleoeclimatology.
Şile Neogene Basin (ŞNB) is one of the world’s crucial sedimentary clay-sand-coal basins, where approximately 3 million tons of clay and 20 million tons of sand are produced annually. The ŞNB, with a thickness of
Geology of the Kurucaşile - Cide region, NW Türkiye
Authors:
Okan TÜYSÜZ
ABSTRACT
The lowest unit of the Cide-Kurucaşile region is the Carboniferous coal-bearing terrestrial sediments. Permian aged terrestrial Çakraz Formation and the Triassic lacustrine Çakrazboz Formation unconformably overlie the Palaeozoic sequence. Dogger-aged Himmetpaşa Formation represents a short-period marine invasion. The transgression started in the Kimmerician has led to the development of a carbonate platform, which has risen and demised after the Berriasian. A second carbonate platform, much more limited than the previous one, developed in the Late Barremian, and then the whole region deepened. The Cenomanian is a period of regional uplift and erosion. The first effective volcanic activity in the region started in the Middle Turonian. During this period, Extensional faults coeval with the deposition, and the region gained an irregular topography. In the Middle-Late Santonian, the volcanism became silent for a while, the region rapidly subsided and became a completely deep marine environment. These events indicate that the continental crust of the region was broken up and the oceanic crust began to develop in the Western Black Sea back-arc basin. In the Campanian, the volcanism reactivated, but ceased after a short time, leaving its place to pelagic sediments forming the southern passive continental margin deposits of the Black Sea. In the Maastrichtian, the region was tectonically compressed and uplifted and provided turbiditic material to the Black Sea in the north and the Devrek Basin in the south. Siliciclastic turbidites have been deposited in the region until the Middle Eocene. At the end of the Middle Eocene, following the uplifting of the entire region and the destruction of marine environments, the north-vergent thrusts were developed due to intense compression and the region became a fold-thrust belt. https://doi.org/10.19111/bulletinofmre.884651
Keywords:
İstanbul Zone, Western Black Sea Basin, Ulus Basin, Cide-Kurucaşile, Stratigraphy.
Engin MERİÇ, Niyazi AVŞAR, Atike NAZİK, Baki YOKEŞ, Özcan DORA, İpek F. BARUT, Mustafa ERYILMAZ, Feyza DİNÇER, Erol KAM, Abdullah AKSU, Halim TAŞKIN, Asiye BAŞSARI, Cüneyt BİRCAN, Aysun KAYGUN
Indexed In · Volume 145 / 2012
THE INFLUENCES OF OCEANOGRAPHICAL CHARACTERISTICS OF THE NORTH COASTS OF KARABURUN PENINSULA ON THE BENTHIC FORAMINIFERAL AND OSTRACOD ASSEMBLAGES
Authors:
Engin MERİÇ, Niyazi AVŞAR, Atike NAZİK, Baki YOKEŞ, Özcan DORA, İpek F. BARUT, Mustafa ERYILMAZ, Feyza DİNÇER, Erol KAM, Abdullah AKSU, Halim TAŞKIN, Asiye BAŞSARI, Cüneyt BİRCAN, Aysun KAYGUN
ABSTRACT
Major differences in foraminiferal assemblages have been observed between the eastern and western coasts on the northern part of the Karaburun Peninsula. In contrast to the rich fauna of the western coast, a poor assemblage was found on the western coast, which is located in the Gulf of İzmir. A great difference in population sizes have also been observed in Amphistegina lobifera Larsen assemblages found on the Aegean coasts of Karaburun Peninsula and Gulf of Izmir. In the frame work of this study, 84 foraminifer species were identifi ed. The most abundant species were Peneroplis pertusus (Forskal), P. planatus (Fichtel and Moll), Amphistegina lobifera Larsen, Elphidium crispum (Linné). Highest heavy metal pollution was observed in the inner part of the gulf, where least number of foraminifera species observed. 24 ostracod species were identifi ed. Our fi ndings showed that the number of genera and species of ostracods increases with the increasing depth and the distance to the shoreline on the NW of Karaburun Peninsula. Loxoconcha rhomboidea (Fischer), Xestoleberis communis Müller and X. depressa Sars were found to be dominant species on the NW of the peninsula, whereas on the NE of the peninsula Xesteleberis dispar Müller dominated the fauna, Xestoleberis communis Müller and X. depressa Sars were the other abundant species. The aim of this study is to investigate the foraminiferal assemblages of the north coasts of Karaburun Peninsula and fi gure out the effects of mercury mine and other elements on these assemblages. Two mercury mines are found on the north of the peninsula, “Karareis” located on the northwestern of Tuzla Cove and “Kalecik” on the southwestern of Karaburun. Both mines have been economically operated since ancient times until 1970s. However, mercury mineral has not been observed in the muck found in the vicinity. The piles of muck may be washed with rains, resulting in the draining of the acidic solutions with Hg, As and Fe to the nearby seasonal stream, which are then possibly carried to the sea. The sea water samples collected from the two locations showed differences in their heavy metalsand trace element contents, such as Al, Si, Cr, Mn, Fe, Co, Ni, Cu, Zn and As, but no signifi cant difference was observed in Hg. The aim of this study is to fi gure out the effects of the heavy metals, which were carried from the land, on the benthic foraminiferal assemblages.
Saruhan SAKLAR, Haşim AĞRILI, Okan ZİMİTOĞLU, Bülent BAŞARA, Uğur KAAN
Indexed In · Volume 145 / 2012
THE CHARACTERIZATION STUDIES OF THE NORTHWEST ANATOLIAN HALLOYSITES/KAOLINITES
Authors:
Saruhan SAKLAR, Haşim AĞRILI, Okan ZİMİTOĞLU, Bülent BAŞARA, Uğur KAAN
ABSTRACT
The extraction and characterization studies were carried out on representative samples which were taken from iron bearing parts of halloysite, halloysite/kaolin deposits located in Çanakkale – Balıkesir vicinities in Northwest Anatolia. Halloysites in these samples are generally in the form of hydro halloysite (10 Å) and kaolinite could also be encountered in some parts. Minerals for primary source of pollution in halloysite and kaolin deposits are limonite (geothite) and muscovite. These minerals might contain clay minerals such as; quartz, feldspar, gibbsite, smectite and anatase in their structures. The iron content of the clays can be reduced signifi cantly by hydrochloric or oxalic acid treatments. Transmission electron Microscope (TEM) and Scanning Electron Microscope (SEM) analyses on Halloysite samples were carried out and it was noticed that halloysite tubes were in cylindrical shape, and in some cases; pores on their surfaces could be observed as a structural feature. In samples studied, tube lengths were measured up to 5 μm by means of SEM analyses, however; TEM analyses have indicated that internal diameters of tubes could decrease down to 5nm and their average diameters ranged in between 40 – 50 nm.