Home›DELINEATION OF THE CR MINERALIZATION BASED ON THE STREAM SEDIMENT DATA UTILIZING FRACTAL MODELING AND FACTOR ANALYSIS IN THE KHOY 1:100,000 SHEET, NW IRAN
Article Details
DELINEATION OF THE CR MINERALIZATION BASED ON THE STREAM SEDIMENT DATA UTILIZING FRACTAL MODELING AND FACTOR ANALYSIS IN THE KHOY 1:100,000 SHEET, NW IRAN
BULLETIN OF THE MINERAL RESEARCH AND EXPLORATION (MTA Dergisi)
Article Details
DELINEATION OF THE CR MINERALIZATION BASED ON THE STREAM SEDIMENT DATA UTILIZING FRACTAL MODELING AND FACTOR ANALYSIS IN THE KHOY 1:100,000 SHEET, NW IRAN
Fractal methods are regarded as a highly efficient method for more accurate separation of boundaries between mineralized zone in shallow and deep studies. In this research, concentration-number (C-N) and concentration-area (C-A) fractal methods were used in order to identify promising areas of the elements like Cr, Co and Ni in the Khoy 1:100,000 geological mapping sheet, NW Iran. The factor analysis was performed on the elements, and factors, which were related to the elements, were isolated and studied by both fractal methods. The current geological locations of the extreme anomalies were investigated and the results showed a very close relationship and overlapping. The results of the presented models show that the most elements under study are located in the central and southwestern parts of the sheet. From the point of view of the lithology, these areas correspond to the serpentinite ultramafic units of harzburgite and dunite, and as a result, there is a high probability of Cr mineralization. The achieved results are confirmed by factor analysis. This means that a factor accumulation of these elements is exactly the same as those of each element.
A thorough comparison of newly discovered whetstone from the Dazkırı (Afyonkarahisar – Türkiye) with a heritage whetstone from the Cretan Island-Greece with regards to mineralogical, petrographic and physico-mechanical characteristics
Authors:
Osman Serkan ANGI, Orhan YAVUZ, Emin ÇİFTÇİ
ABSTRACT
The present study is an analytical investigation into the geomaterial and engineering geological characteristics of Cretan (Greece) and Dazkırı (Afyonkarahisar, Türkiye) whetstones. The Cretan whetstone, a prominent example of a heritage natural whetstone, is a distinctive type of carbonatecemented siltstone that is extracted from the island of Crete in Greece. Conversely, a new specimen was recently identified by the authors and designated as “the Dazkırı whetstone,” which exhibits comparable lithology and is extracted in the Dazkırı district of Afyonkarahisar (Türkiye). In order to ascertain the geomaterial characteristics of the studied whetstones, a number of analytical and test techniques were utilized. Furthermore, Cerchar Abrasivity Index (CAI) measurements were conducted and acquired. The CAI results were then compared through the use of regression equations related to quartz content, cementation degree, and the Böhme surface abrasion resistance. The oil absorption test was finally conducted to ascertain the grinding-honing performances and impregnation capacity with lubricant of the examined whetstones. Consequently, a comparative analysis of the subject whetstones was conducted, resulting in the definition and classification of their characteristics. These characteristics included the relationship between grain size and grit size equivalent, as well as the type of lubricant, function, and uses. In summary, the Dazkırı whetstone exhibits superior geomaterial characteristics and grinding-honing performance when compared to the Cretan whetstone.
Keywords:
Whetstone, The Cretan Whetstone, The Dazkırı Whetstone, Geomaterial Characteristics, Grinding- Honing Performances.
Formation of carbonate-hosted Kızılüzüm Pb–Zn–Ag deposit within the Bornova Flysch Zone, İzmir, Western Türkiye
Authors:
Bezhan BEHZAD, Cem KASAPÇI, Nurullah HANİLÇİ
ABSTRACT
The Kızılüzüm Pb-Zn-Ag deposit is hosted within carbonate rocks belonging to the Bornova Flysch Zone (BFZ) in Western Anatolia. The base of the BFZ in the study area comprises Upper Cretaceous recrystallized dolomitic limestones with rudist fossils, overlain by Late Cretaceous-Paleocene flysch-type sequences consisting predominantly of fossil-free sandstone and shale alternations, along with occasional limestone lenses. Cataclastic granitic dike, possibly of Miocene (?) age, intrudes these units. The BFZ exhibits an imbricated internal structure, and the Kızılüzüm Pb-Zn- Ag mineralization has developed within the recrystallized dolomitic limestones particularly at the intersections of low-angle thrust zones and faults. The ore zone is oxidized and contains 0.4-44% Zn, 0.2-12.5% Pb, 65-3305 ppm As, and 1.5-347 ppm Ag. The moderately strong correlation of Ag with Pb and sulfur (r = 0.7) suggests its association with galena. Fluid inclusions yield an average homogenization temperature of 238 °C (Th) and 5.4 wt.% NaCl equivalent salinity, indicating a dominantly magmatic-hydrothermal origin for the ore-forming fluids. δ34S for sulfide minerals average -6.89‰ (range: -11.95‰ to 4.46‰; n = 27), while barite shows 8.75‰ (range: 0.67‰ to 14.05‰; n = 5). These data suggest that sulfur may have been derived from dominantly magmatic sulfate sources with partly sedimentary sulfate contribution, reduced and fractionated through thermochemical sulfate reduction (TSR) processes. Considering its geological setting, mineral paragenesis, fluid inclusion data, sulfur isotope compositions, and ore geochemistry, the Kızılüzüm Pb-Zn-Ag mineralization may have been formed through the mixing of magmatic-hydrothermal fluids derived from Oligocene-Miocene magmatic rocks intruded into the Bornova Flysch Zone (BFZ) and shows similarities to Carbonate Replacement Deposit (CRD)-type Pb-Zn deposits worldwide.
Dornadula CHANDRASEKHARAM, Govind UMMETHALA, Tripathi RAJENDRA PRASAD, Amir Hossein TAVABI, Sairam Krishna MALLADI, Rafal E Dunin BORKOWSKI, Dixit AMBESH
Indexed In · Volume 180 / August 2026
High resolution microscopy and Raman spectroscopic studies on the freshest Mukundpura meteorite, Rajasthan, India: Presence of nanodiamonds
Authors:
Dornadula CHANDRASEKHARAM, Govind UMMETHALA, Tripathi RAJENDRA PRASAD, Amir Hossein TAVABI, Sairam Krishna MALLADI, Rafal E Dunin BORKOWSKI, Dixit AMBESH
ABSTRACT
Carbonaceous Chondrites have special significance in the stellar evolution and in particular in the evolution of life on earth. The carbonaceous meteorite that fell in Mukundpura village, Jaipur, Rajasthan on 6th June 2017 is one such rare CM2 (Carbonaceous Chondrite) carbonaceous meteorite. We carried out high resolution scanning and transmission electron microscopic (SEM and TEM) studies on typical thin sections, showing abundant grains of iridium (Ir), pentlandite (NiS), and more interestingly crystalline carbon (C). These crystallite carbon grains resemble nanodiamond like signature in the freshest Mukundpura meteorite. The high-resolution Raman spectroscopic measurements are carried out on the crystalline carbon grains, showing well resolved three distinct peaks with a vibrational mode at 1315 cm-1, with the onset of a weak vibrational mode at 1150 cm-1, substantiating the observation of nanocrystalline diamond in Mukundpura meteorite. The broad peak centered at 1360 cm-1 and 1575 cm-1 (as an average), suggest the presence of graphitic carbon as well together with apparent presence of nanocrystalline diamond. The average size of nanocrystalline diamond is ~ 3-5 nm. High iridium content in this meteorite supports the meteoric impact related iridium anomaly in geological stratigraphic boundaries (e.g. Cretaceous-Tertiary boundary) that has caused mass extinction of flora and fauna.
Keywords:
Meteorite, Mukundpura, Nanodiamond, Raman Spectroscopy, TEM, Iridium Anomaly, Pentlandite, Mass Extinction.
The Eskişehir Fault Zone is one of the prominent neotectonic structures of Turkey. It separates the west Anatolian extensional province and the strike-slip induced northwest central Anatolian contractional area in the Anatolian Block. Its southeastern part is generally divided into three branches, namely the Ilıca, Yeniceoba, and Cihanbeyli from north to south, respectively. The right lateral strike-slip Ilıca branch (IB) is an approximately 100-km-long fault and it is composed of several segments in a northwest-southeast direction. The slickensides, subsidiary fractures, cataclastic zone, fracture-controlled drainage pattern, right lateral stream deflections, deformation in the Quaternary unit observing in the seismic reflection sections, and seismicity of the region all indicate that the IB is an active right lateral strike-slip fault. The IB has also a regional tectonic importance as a boundary fault between the contractional and the extensional regions in central Anatolia considering that it is the southern limit of the contraction-related structures in the west-southwest of Ankara.
Keywords:
Ilıca Branch, Eskişehir Fault Zone, Neotectonics, StrikeSlip, Central Anatolia
PHYSICOCHEMICAL PROPERTIES AND USES OF KARACAÖREN AREA (NEVŞEHİR) DIATOMITE
Authors:
Ayşegül YILDIZ, Ali GÜREL, Yusuf Gökhan DURSUN
ABSTRACT
In this study, physicochemical properties and uses of diatomites which are formed due to Central Anatolia volcanism and outcropping in Karacaören (Ürgüp country, Nevşehir) area were investigated. Two stratigraphic sections were measured in the investigated area, one of these sections was measured in the Quaternary lake units (K1), and the other section was measured in the lacustrine sediments of late Miocene-Pliocene Ürgüp Formation’s Bayramhacılı Member (K2). The specify to physicochemical properties and uses of study area’s diatomite, loss on ignition (1050 ° C), XRD, amount of acid and water-insoluble matter, thermal conductivity (in the range of 101; 150 ° C and ± 10 ° C), XRF, pH, total porosity, specific gravity, specific surface area, pore volume, pore size, whiteness, particle size and SEM analysis were carried out at the General Directorate of Mineral Research and Exploration Laboratories on the samples collected from the area. The evaluation of the analyses results showed that, the subject diatomites have commercial value and it can be used directly in percolator, as a filler and structuring agents and in the manufacture of silicate. In addition, it can be used as mild abrasive and cleaner, in the manifacture of isolution material after processing
Keywords:
Uses Of Diatomite, Physicochemical Properties, Late Miocene-Pliocene, Karacaören, Quaternary
PRODUCTION OF AN INSULATION MATERIAL FROM CARPET AND BORON WASTES
Authors:
Yasin ERDOĞAN
ABSTRACT
Buildings are large consumers of energy in all countries. In regions with harsh climatic conditions, a substantial share of energy goes to heat and cool buildings. This paper reports an investigation of the insulation materials made from mixing carpet wastes with a solution with added crude colemanite ore, one of boron minerals, and a solution with added colemanite wastes from a barrage. A new building insulation material was produced which is name, Halibor. Optimum mixing ratios were determined for mass production and the physical properties of the product were established. In addition, the material produced was compared with similar products used in buildings in terms of physical properties. As a result of the investigations, it was established that the product provides high heat and sound insulation and can be used easily in building and construction industry.